Hi All,
Does anyone have any experience of working on this radio, its the small Grundig with a leather case designed by F.A. Porsche.
I have recently repaired one with corroded battery contacts which had obviously not worked for many years.
Its now working perfectly on FM, but MW and SW1 and SW2 have no reception, just noise.
If I leave the radio connected to a 5v power supply for many hours it does actually get some reception on AM, but its not consistent. I'm thinking the fault is somewhere in the 'front end', oscillator stage perhaps.
I have checked the AM coils and wave selector switch are OK and everything is visually in excellent condition.
Reading various reviews on this radio confirms they were sold very cheaply in the USA and many customers have complained there is little or no sensitivity on AM, whilst others say it works perfectly. This makes me wonder if there is a common fault on these which someone may know, before I start with my test equipment to try to find the problem...
Any advice would be much appreciated!
Udv mindenkinek, Egy kis segitseget szeretnek kerni a tisztelt kolegaktol. Egy Grundig Car 2002
auto radioba a kodot nem sikerul beirnom . Lehet hogy nem jol tudom a procedurat. Tudna valaki segiteni ebbe? Elore is koszonom.
Tisztelt kollegák4
Keresek UPD1703C-11 IC-t a fenti grundig erősítőhöz. A szervizdokumentáció alapján nem ad ki FM hangoló feszültséget.
Akinek esetleg van IC-je vagy rossz készüléke amiben ez megtalálható, kérem jelezzen!!!!
Üdv!
Sziasztok!
Valamelyik nap belehet kapcsolni, valamelyik nap nem, amikor bekapcsolódik akkor egész nap jó minden--ezt mondja a tulaj. Nekem nem sikerult még bekapcsolnom.
Csak a piros stby led világít, display-en semmi nincs. Gomb megnyomásakor sem erôlködik ugyanugy világit a piros led.
Van külön stby trafója ez ad +5V-ot, meg +10V-ot! ad 12V-os relé egyik lábára, a GND-t a relé másik lábára egy kis npn tranzisztor kapcsolja rá ha a processzor ad neki valoszinu +5V-ot, de 0V van a processzor MN101C15F kimeneti 52.lábán (POUT). A relé kapcsolja a nagy trafó primerjére a 230V-ot.
A gombok jók- kilehet huzni a szalagkabelt és akkor 2Mohm-os határon is szakadás van. Gombok ellenállást kapcsolnak sorba az 5V-ra, a stby gomb 19kohm-ot kapcsol rá és 3.3V lesz amíg nyomom a gombot.
Még nem mértem rá a kvarcra..