Service manuals, schematics, eproms for electrical technicians
JVC LT-Z37DX5-SERVICE-MANUAL
Type: 
(PDF)
(PDF)Size
1.5 MB
1.5 MB
Page
27
27
Category
TV
SERVICE MANUAL
TV
SERVICE MANUAL
If you get stuck in repairing a defective appliance download this repair information for help. See below.
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar jvc manual?
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar jvc manual?
Advertisements
Document preview [1st page]
Click on the link for free download!
Document preview [2nd page]
Click on the link for free download!
Advertisements
Please tick the box below to get download link:
- Also known:
JVC LTZ 37 DX LT Z37DX5
- If you have any question about repairing write your question to the Message board. For this no need registration.
- If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site.
Have a nice Day! - See related repair forum topics below. May be help you to repair.
Warning!
If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
Note! To open downloaded files you need acrobat reader or similar pdf reader program. In addition,
some files are archived,If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
Translate this page:
Relevant TV forum topics:
JVC AV-21FMG4G Chassis SCW-1362A CRT TV blinks continuously after three failing power on attempts.
According to the customer, the upper portion of the screen started shrinking with horizontal lines, then ended with a single thin horizontal line.
This suspects the vertical drive section to be problematic. No vertical output though vertical in put is OK. After conducting an ESR check for capacitors in the vertical section, C428 (100uF 35V), connecting VCC1 with Pump-up pin # 3 of the IC, it measured 1200pF. It was replaced but still no vertical output. So changed the vertical IC401 (TDA78040), and the output appeared, but still blinks after three failing start-ups. I, m suspecting the corrupt EEPROM data.
CPU: TDA11010H / N1D00
EEPROM: 24C16A
Any one with EEPROM dump for this model or any help please?
According to the customer, the upper portion of the screen started shrinking with horizontal lines, then ended with a single thin horizontal line.
This suspects the vertical drive section to be problematic. No vertical output though vertical in put is OK. After conducting an ESR check for capacitors in the vertical section, C428 (100uF 35V), connecting VCC1 with Pump-up pin # 3 of the IC, it measured 1200pF. It was replaced but still no vertical output. So changed the vertical IC401 (TDA78040), and the output appeared, but still blinks after three failing start-ups. I, m suspecting the corrupt EEPROM data.
CPU: TDA11010H / N1D00
EEPROM: 24C16A
Any one with EEPROM dump for this model or any help please?
| Sziasztok
A tárgyban jelzett tv néha hidegen bekapcsol, melegen sosem csak a készenléti ledet villogtatja. Neten talált tartalommal (U12) 25Q64-ba beírva szintén nem indul.Lenne valakinek jó mentése hozzá? Alaplap 17MB82-2 kijelző VES315WNVL-01-B. Lehet tévúton vagyok és az (U10) 25q16-ot kellene újraírni? Köszi |
| Sziasztok! A fenti 17MB211S lappal szerelt VES395UNDC-2D-N12 kijelzős gép furcsa dolgot produkál. Be-kikapcsolható, de semmilyen funkció nem érhető el, mert ahogy megnyomom a házikót, egy pillanatra beugrik a menü (alapból a smart ikonok láthatók) és azonnal visszalép tv üzemmódba. Ugyanez a helyzet a bemenetválasztónál és a hangerőszabályzónál is. USB-ről viszont lejátssza a filmet. Ráadásul talán arabul ír mindent. Van esetleg ehhez valakinek CORE UPDATE? Vagy fizikai problémája lehet? Előre is köszi, ha valaki tud segíteni! |
Sziasztok!
Alaplap csere után oldal irányban kettős vonalak vannak egyébként szép lenne a kép. Nem teljesen stimmelnek a számok a lapon de a kijelző típusa stimmel.
Szoftver nem teljesen stimmel, nincs valakinek frissítő fájl ehhez a típushoz?
Átraktunk a rossz lapról a NAND flash-t és jó lett a kép, tehát a kijelző adatok a NAND flashben vannak. Aztán nem talált adót ezért a tunert is át kellett rakni.
Similar manuals:
If you want to join us and get repairing help please sign in or sign up by completing a simple electrical test
or write your question to the Message board without registration.
You can write in English language into the forum (not only in Hungarian)!
or write your question to the Message board without registration.
You can write in English language into the forum (not only in Hungarian)!
E-Waste Reduce