Sziasztok!
Üdv. mindenkinek!
A tárgyban szereplő (legkisebb SONY) hangprojektor kiválóan működik, de a kezelése, használata terén célszerű volna véltoztatni.
Nevezetesen számomra nem elég felhasználó barát, hogy a TV indítása után minden esetben külön kell bekapcsolni a távszabályzóval a pjorektort és a hangerőt "ráadni", mivel nulláról indul.
Sem a bekapcsolást, sem a hangerőt (jelen esetben pld. a maximumot) nem tárolja el, így a rendszer használatához min. 2, esetenként 3 távszabályzó kell (TV, STB, Hangpjorektor).
Kényelmesebb lenne, ha pld. "áram alá helyezve" mindig elindulna és a beállított vagy a max. hangerőn "szólna" is.
Ha kb. 20 percig nem kap vezérlést, kikapcsol, de onnan sem indul el automatikusan.
Megoldható-e vagy hardveresen, de inkább - gondolom - szoftveresen ezeken módosítani?
A panelján több smd IC található hűtőbordával leragasztva (köztük 1 nagyobb - gondolom processzor), szervízkönyv, rajz természetesen nem elérhető sehol sem.
Valakinek tapasztalata, ötlete?
Üdv: Sándor
Jó napot mindenkinek!
A gondom az hogy mikor hozzám került a panasz az volt hogy recseg , kontakt hibás. Én nem próbáltam ki, mert a testvéremé, hanem szétszedtem, és átforrasztottam.Most megy a kijelző, mutatja hogy keres a tuner, váltja a bemeneteket , de egy árva hang se jön ki.Volna valakinek rajz hozzá, mert nekem nincs.Így meg nem is tudom hol kezdjek hozzá.
Előre is köszi.
dínó
Want to share:
Have downloaded the schematics from this forum to help repair the amplifier of a friend.
Turned out that Sony decided to route the earth through the chassis, even the earth between the various supplies.
When one takes the main board out of the chassis and switches the amp on, there are up to 20 volts difference between the eart (and hence reference) of the pre-amps and the main amps.
Luckily the amp goes into protection but from a design point of view it is not nice to rely on screws and aluminum face plates to conduct up to 0.2 amps of current from one supply to another.
What I did is solder wires to every eart point and connected them on the main board to make it stand alone and not rely on conducting current through the chassis anymore.
Bad design, simple repair but took some digging in the schematics to find out what exactly was going on!
Hi!
Az említett erősítő megadta magát, még a relé sem húz be.
Szervízoldalakon láttam a tipikus hibajavítási ötletek között ezt a "relé nem (sem) húz be" problémát, csak sajnos nem férek hozzá.
Valakinek esetleg ötlete, tapasztalata?
Nagyon köszi!