üdv mindenkinek: keresem ennek a lengyel varrógépnek(Finesse 884) a mechanikus beállítási rajzát, pontosabban a tű alatti forgótárcsa pozíciója kellene alsó vagy felső holtpontban.Valami elállítódott, tépi a cérnát.
Ráadásul saját gép, most az asszony nyúlt hozzá.
Képek:
DSCN0057.jpg
DSCN0058.jpg
Előre is kösz, ha valaki tudna segíteni.
Bálint
Sziasztok
Adott egy ilyen
futopad.
Teljesen ujszeru allapotban van, az elado szerint egyszeruen megallt es nem csinal semmit.
Ezzel szemben, en amikor otthon bedugtam, akkor csattanast eszleltunk az alaplaprol (pedig szerintem nem lehetett paras, kondenzes).
Amikor megneztem, akkor nagy kar nyomait lattam az alaplapon: elolvadt labu tranzisztor, fel ellenallad, kupak nelkuli IC, stb.
Barmennyire csabitonak tunik, hogy megjavitsam, de ha realista akarok lenni, akkor azt mondom: nagyon nehez lenne, ha nem lehetetlen.
Ez az alaplap van benne:
MC2100ELS-18W
279167
Vendor: 4679
D/C: 1438
Szetneztem a szokasos helyeken (ebay, aliexpress, stb), talaltam is elerheto arban alaplapot, aminek ugyan megegyezett a kodja, de a felepitese gyokeresen kulonbozik. Nem tudom, kompatibilis-e. Ami meg jo arban lett volna az mind vagy USA vagy Ausztralia. Van egy ausztral pasas aki 7 darabot ad el "teszteletlen" allapotban, 85 dollarert, de draga a szallitas.
Tekintve, hogy ezt Magyarorszagon is forgalmaztak, hatha van nektek, vagy tudtok egy elerheto aru beszerezhetoseget.
Termeszetesen ha van valos esely arra, hogy megjavitsam, akkor rajz vagy szervizkonyv is erdekelne.
Elore is koszonom valaszaitokat.
Minden jot,
Janos