Sziasztok ! Ez egy WKC 3300 RDS magnó , calkuláltam neki kódot , de nem eszi ! GR1028Y0135641 gysz : 0962 jött ki ! Nem valószinü hogy át lett égetve , mert még rajt van a garos cimke ! Megköszönném ha valaki megpróbálná !! lehet hogy az én progim nem jó !
40 éves készülék, régi vágyam volt, most megvan. A jobb csatorna torzít. Ha a bemenetre színuszjelet adok, a jobb csatorna jelalakjának alja torzul. Az előrerősítő modul potijain állítva a jelalak felveszi a színuszt, de ha növelem a hangerőt , akkor ismét torzul a kimeneti színusz alsó hulláma. Ötleteket várok, és mindenképpen írom a végeredményt. A végfokot ellátó 2-2 db 10.000uF elkó mindenképpen cserélve lesz már úton vannak.
Hiba oka. A végfokhoz A,B,C,D,E pontokon csatlakozó “Power limiter” áramkörben zárlatos volt a 2SA777 pnp tranzisztor, és az egyik MA150 dióda. Emiatt ez a szabályzó áramkör fals jelet vitt a vegfok jelébe. átmeneti megoldásként, a tranzisztort BC327-tel, ( más éppen nem volt ) cseréltem, a dióda is cserlve lett. Hibátlanok a jelalakok.
Hello.
here is a message to share my experience in solving a problem that appeared on the home-cinema amplifier ONKYO tx-DS494.
In order to sell this amplifier I had to check if all the outputs and all the functions works properly.
On the back of this amplifier you have to frontal output : A and B.
I connect a pair of speaker on A output : no problem. I can adjust volume.
when i connect the pair to the b output and turn the volume knob no sound came out of the speakers until I reach a level defined by I don't know what. :hmmm: My volume level goes from 0 to 80db ( if I remember well ). from 0 to 23 db no sound and when I reach 24 dn sound increase and stabilize.
With hearphone connected, i don' have this problem so I conculde that amplifing transistor could not be incriminated.
I checked on the service manual and saw that there are two or three component that could be the source of the problem : the main processor, some capacitors on the output PCB and relays.
I began testing capacitors: no pb. then I thought that if cannot be the main proc because it ( I think ) works in a binary mode: it works or it doesn't. so I decided to switch between themselves the two relay and :super: : it works. The relays was in fault and did not switches properly.
here is my experience in repairing an amplifier
Sziasztok Fórumtagok! esetleg kapcsolási rajza valakinek ehhez?
Én nem találtam a neten! Régi. Az van hogy torzít kicsit recsegve meg halk is!
A vég és meghajtó tranyók műszerrel mérve jónak tünnek. Talán valamelyik kondi lenne a hunyó?
Rajz nélkül nehéz meg nehezen is szerelhető! Előre köszi a válaszokat! Sziasztok