Given:
Victor TT-71, neon lamp does not light, speed is lower than normal. This is subsequent some short circuit the owner does inside the device. No further details.
I found out the VICTOR QL7 have the same motor driver amd I downloaded the service manual that I attached here in case this manual is not already uploaded.
Looking at the diagrams I found out that at TP3 (same with pin5 of IC803) instead if that rectangular signal, I have nothing but 5VDC and a negative or positive short spike whenever I'm starting or stopping the motor and
Under the circumstances I suspect IC803 is defective. The bad thing, IC803 is NPC SC8043. Also I wonder if the crystal is fine (except that I wonder what can be wrong with a crystal after some short circuit).
Does anybody have any more suggestion?
Also, where can NPC SC4043 be sourced? Also, a crystal 9.054MHz?
Thanks in advance,
Corneliu
Üdv Mesterek.!
Sony GTK-XB7 Erősítővel bajlódok.
Elmondás szerint csak megállt.
Hála a rajz a Tanyán megvolt.
A készenléti 5V nincs.
A rajz részletről van szó.
A bemenet 36V megvan , kimeneten 1.6V van , úgy hogy az áramkör le van választva a 2 2A kimeneti biztosítónál.
Minden elem átnézve , jó ,Így csak az IC LEHET HIBÁS.
Zárlatos volt a D1 3D dióda, természetesen előtte semmi nem volt.
De hogy lehet hogy a bemeneti 2A biztosíték nem ment ki ?
Ic.t (EUP3490 ) , nem találtam , legalább is aminek a lábkiosztása megegyezne.
HQ /LM2596S) 40V/3A , de más a lábkiosztás.
SMD IC , tehát nincs mód forgatásra.
Ha tudna valaki segíteni , megköszönném.
TME-nél elvileg van , de nincs kép róla.
Köszönettel: Öreg Tom
Sziasztok!
Fenti panelon az L102 mellett és a D101 fölött megégett 8 lábú smd eszköz van.Dc konverternek gondolom.Ami olvasható rakta 5.31. 5 AM. 7K.
Tud valaki segíteni? Üdvözlettel Reparator1
Tanyalakók !
Van két vadonatúj, 10000uF, 100V, 105C, SIEMENS kondenzátorom.
Ha valakit érdekel.
Üdv.
gergosz01