Want to share:
Have downloaded the schematics from this forum to help repair the amplifier of a friend.
Turned out that Sony decided to route the earth through the chassis, even the earth between the various supplies.
When one takes the main board out of the chassis and switches the amp on, there are up to 20 volts difference between the eart (and hence reference) of the pre-amps and the main amps.
Luckily the amp goes into protection but from a design point of view it is not nice to rely on screws and aluminum face plates to conduct up to 0.2 amps of current from one supply to another.
What I did is solder wires to every eart point and connected them on the main board to make it stand alone and not rely on conducting current through the chassis anymore.
Bad design, simple repair but took some digging in the schematics to find out what exactly was going on!
Üdv mindenkinek.
Csabai Dániel magnósok évkönyben csak egy általános leírás van az 1980as kiadásban.
A címben említett kapcsolási rajz lenne igazi.
Valamelyik 80-s évekbeli ezermester magazinban volt cikk erről a hangfalról. Ha valaki tudja melyik szám, lehet az elég is.
Vagy aki újított/restaurált ilyet, nála érdeklődnék.
(Egyes videoton termékekhez alapból adtak szervízmanualt, ehhez nem?)
néhány kép
https://avxforum.hu/forum/viewtopic.php?t=137454
köszönettel D Attila
Kedves Mindenki!
Tudna-e nekem valaki hasznos tanáccsal segíteni, a fenti típusú készülék klasszul működik de... ISZONYÚ HALVÁNY A KIJELZŐJE és már nagyon égek a gyerekeim előtt valamit kellene vele csinálnom tudnátok segíteni? Köszi előre is :-) Üdv Róbert
Sziasztok!
Ennek az erősítőnek csak egy csatornája szól, a végfokokat átmértem de semmi gondot nem találtam nála. Az előerősítő icék megkapják a tápfeszeket, BA4560 van benne ( 12db ) ezekkel lehet gond, vagy más valami? Esetleg valaki találkozott ezzel a géppel, rajz?