Given:
Victor TT-71, neon lamp does not light, speed is lower than normal. This is subsequent some short circuit the owner does inside the device. No further details.
I found out the VICTOR QL7 have the same motor driver amd I downloaded the service manual that I attached here in case this manual is not already uploaded.
Looking at the diagrams I found out that at TP3 (same with pin5 of IC803) instead if that rectangular signal, I have nothing but 5VDC and a negative or positive short spike whenever I'm starting or stopping the motor and
Under the circumstances I suspect IC803 is defective. The bad thing, IC803 is NPC SC8043. Also I wonder if the crystal is fine (except that I wonder what can be wrong with a crystal after some short circuit).
Does anybody have any more suggestion?
Also, where can NPC SC4043 be sourced? Also, a crystal 9.054MHz?
Thanks in advance,
Corneliu
Kedves kollégák!
Egy autórádióban találkoztam ezzel a kvarccal, de semmi infót nem lelek róla. Pici, hengeres tokozása van, a jelölésben a D betű szára át van húzva.
![](http://www.ru.all.biz/img/ru/catalog/118097.jpeg)
A kapcsolási rajzon nincs feltüntetve frekvencia, a típus is csak egy JVC azonsító szám. ( QAX0401-001 )
Minden infót köszönök!
Üdv: Jácint
Sziasztok!
Ez az autórádió a protect felíratott jelzi ki, eddig a végfokot cseréltem ki de a hiba megmaradt. Milyen gond lehet ez?
Sziasztok!
Egy JVC fejegység előlapjában lévő xtal hol rezeg, hol nem. Amikor hibátlanul működik akkor 10MHz 6,7Vpp mérhető a lábain. A készülék pontos típusát most nem tudom, de pótolni fogom. Kérdésem, hogy honnan lehetne beszerezni ilyen, a mellékelt képen látható (X801 pozíciószámú) kvarcot? Körbenéztem de a kapható SMD tokozások hatalmasak, sehogy sem férne bele.
Pótoltam a típust!
Köszönöm.
Üdv.