Service manuals, schematics, eproms for electrical technicians

KORTEK LCD MONITOR

MONITOR - SERVICE MANUAL
Type: (PDF)
Size
654.9 KB
Page
5
Category
MONITOR
SERVICE MANUAL
If you get stuck in repairing a defective appliance download this repair information for help. See below.
Good luck to the repair!

Please do not offer the downloaded file for sell only use it for personal usage!

Looking for similar kortek manual?
Advertisements
Document preview [1st page]
KORTEK LCD MONITOR service manual (1st page)
Preview of KORTEK LCD MONITOR [1st page]
Click on the link for free download!
Document preview [2nd page]
KORTEK LCD MONITOR service manual (2nd page)
Preview of KORTEK LCD MONITOR [2nd page]
Click on the link for free download!
Advertisements
Please tick the box below to get download link:
  • Also known:
    KORTEK LCD MONITOR
  • If you have any question about repairing write your question to the Message board. For this no need registration.
  • If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site.
    Have a nice Day!
  • See related repair forum topics below. May be help you to repair.
Warning!
If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!

Note! To open downloaded files you need acrobat reader or similar pdf reader program. In addition, some files are archived,
so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
Translate this page:
Relevant MONITOR forum topics:
Kortek KT-1948 - (párnatorzított, széles kép), most focus probléma
Sziasztok Mesterek! A fenti monitornál erős párnatorzítás és kb. 20%-al megnövekedett sorméret tapasztalható és ez a két paraméter a potikkal alig állítható. A H-Pos és a Vertikális beállítások tökéletesen működnek. A TDA4858 11. lába az E-W kimenet. A sajátján kívül két másik IC-t próbáltam már bele. Minddel ugyan ezt produkálja. A potitkat már kimértem, meg is kapják a +5V-ot. A 11. lábon a tranyók mérve nem szakadtak/zárlatosak. A sorvégtáp +108V, a +49 az 48,5, a +40V helyett +45V-ot mérek, de ez szerintem belefér (mivel csak a G1 és a szabályzóknak a zeneres +5V-ja táplálkozik ebből.) Viszont a +12V-on és a +6,3V-on kb. 1,5V-os tüskéket látok. Ha jól számoltam ezek a pufferkondik kb. 550uF-osak a 2200uF és az 1000uF helyett. Okozhat ez a táphiba ilyen jelenséget? (amint lesz kondi kicserélem.) Minden segítséget megköszönök! Köszönettel: Gyula u.i.: Rajz mellékelve.
Similar manuals:
If you want to join us and get repairing help please sign in or sign up by completing a simple electrical test
or write your question to the Message board without registration.
You can write in English language into the forum (not only in Hungarian)!

E-Waste Reduce