Sziasztok!
Keresek a tárgybeli készülékhez egy darab 6916L-1174A R1 csíkot. Nem baj ha rossz ledes, csak ne legyen égett. Ami benne volt az 3 cm hosszan elszenesedett az első lednél.
Köszi:Zoli
Dear community,
Please help me solving my issue with my LG OLED55CX3LA TV.
I have this TV since 3 years, never had an issue, until last month, when It suddenly start to freeze. It stuck on white/ or in currently displayed picture, got some pitching noise, and 5-6 seconds later the TV shuts off by itself.
The solution so far is to restart it by the power button, or the power socket, within 10 seconds.
The problem occurs very rarely, sometimes early morning, sometimes 2 days without problems. I have played some HDR videos continuously, with no problems.
I have read about these issues on LG OLED, and most of the cases were caused by overheat of the main processor.
Also read about thermal paste. I have opened my TV and yes, thermal paste was hard as rock.
I have cleaned the processor carefully, and used profesional thermo paste, but that does not solve the problem, unfortunately.
Also, I have done hard reset, used latest firmware update, tried without HDMI inputs, but the problems still persist.
As the problem is not coming very often, I am in research of the correct solution.
I was read that the main board can be used from different LG OLED TVs, and even can get a better processor, kinda upgrade.
Give me please your opinion and advice what is the best solution.
Thanks,
Kalin
Sziasztok!
Ez a készülék tegnap megadta magát, hang van a képernyő sötét de a képernyő tetejétől kb 5cm-re 3 színes csík megjelenik, piros, zöld, kék.
Szemmel látható hibát nem találtam, a 200V meg van, az R-G-B katódokon 125-130V-ot mérek.
Valaki találkozott-e már ilyen hibával?
A válaszokat előre is köszönöm.
Sziasztok!
Van nálam egy LG gép ami MC049A chassival van szerelve. Eredeti hibája a sorvégtranyó volt amit még itt is kerestem a tanyán egy topicban de ajánlottak helyettesítőt ami meg is jött pénteken de csak most volt időm belerakni. Kék tárcsakondi csere sorvégkondi szintén csere, majd le ellenőriztem a sormeghajtást diódákat kondikat stb... és megy rendesen minden. Tranyó belerak és indulásnál egy nagyon furcsa hang a sorvég felől kajakra mintha valami égne és azóta semmi. Tranyó túlélte de most olyat produkál hogy indításnál elhalványul a stby led majd kattan a mág.... relé és vissza áll stby-ba. De ha a tranyót kiveszem és mérem a sormeghajtást minden oké nem áll le stby. Mi lehet ez szerintetek? Ja és a táp tesztelve, nincs elgyengülve.
Üdv:Irkax