Sziasztok! Onkyo TX-7520 manuáljára lenne szükségem ha valakinek megvan köszönöm.
Sziasztok!
Nevezett készülék rádióról és analóg bemenetekről rendesen üzemel, de digitális bemenetekről nem. Kimeneteken szintén nem jelenik meg semmi.
HDMI csatlakoztatását felismeri. Valaki találkozott már ezzel a jelenséggel?
(Gyaníthatóan ez valami típushiba lehet, ezért vetettem fel a témát, mielőtt jobban belemélyedtem volna)
Üdv,Z.
Sziasztok!
Segítségre lenne szükségem egy onkyo tx nr509 erősítővel kapcsolatban. A hiba jelenség a tipikus van kép de nincs hang. Láttam a melegítsük meg a dsp ic-t videót youtube-on de az nem segített, sőt még az ujra bga-zás sem. Olvastam az egyik kolléga fórumában hogy elvileg cserélni kell egy pár alkatrészt és megjavul ez a hdmi panel. Esetleg ha lenne leírás vagy ilyesmi hogy mit kell cserélni azt megköszönném.
Hello.
here is a message to share my experience in solving a problem that appeared on the home-cinema amplifier ONKYO tx-DS494.
In order to sell this amplifier I had to check if all the outputs and all the functions works properly.
On the back of this amplifier you have to frontal output : A and B.
I connect a pair of speaker on A output : no problem. I can adjust volume.
when i connect the pair to the b output and turn the volume knob no sound came out of the speakers until I reach a level defined by I don't know what. :hmmm: My volume level goes from 0 to 80db ( if I remember well ). from 0 to 23 db no sound and when I reach 24 dn sound increase and stabilize.
With hearphone connected, i don' have this problem so I conculde that amplifing transistor could not be incriminated.
I checked on the service manual and saw that there are two or three component that could be the source of the problem : the main processor, some capacitors on the output PCB and relays.
I began testing capacitors: no pb. then I thought that if cannot be the main proc because it ( I think ) works in a binary mode: it works or it doesn't. so I decided to switch between themselves the two relay and :super: : it works. The relays was in fault and did not switches properly.
here is my experience in repairing an amplifier