PANASONIC PV-IQ204 IQ304 IQ404
(RAR)12.6 MB
---
CAMCORDER
SERVICE MANUAL
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar panasonic manual?
No preview item for this file.
Possible causes:
- No preview picture generated yet.
- It is not a pdf file.
- Also known:
PANASONIC PVIQ-204 PVIQ204 IQ304 IQ404 PVIQ 204 IQ 304 404 PV IQ204 PV-IQ204
- If you have any question about repairing write your question to the Message board. For this no need registration.
- If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site.
Have a nice Day! - See related repair forum topics below. May be help you to repair.
If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
initialy the GH5 viewfinder (LVF) would not display anything when I looked through it, indicating a possible issue with the power supply or the internal connection to the viewfinder circuit. So i Opened the camera and inspected the flexible ribbon cable connected to the viewfinder PCB.
-
Identified a potential problem with the FPC connector, which appeared loose and damaged at the pin connection points.But i resolder it.
-
And i Tested the continuity of key components the power board,even the flex cable by cotinuity.
-
After that, testing, the device did not power on at all, even after check the ribbon cable and ensuring the battery was functional.i have 3 diffrents.
-
Currently i'm thinking on check if the power board (DC-in connector) has a short circuit or other internal faults that might have caused the system failure
Does someone can confirm which part i have to test and which component maybe ?Can anyone confirm which specific components I should test further?
Thank you!
The Manual says to adjust the 'Tracking VR" but I have searched the main CBA and can't find any VR with is name on the main CBA.
I was thinking it might be VR2004 the PG Shifter, but I would appreciate if anyone can tell me if this is correct before I make any adjustments
or write your question to the Message board without registration.
You can write in English language into the forum (not only in Hungarian)!