Kicseréltem a régebbi SC-202 rádiómat egy SC-400-asra.
Rengeteg segítséget kaptam.
DE:
Írjátok be az OPEL rádió linkek közé, hogy az alábbi linken rengeteg OPEL rádió infó van:
http://carradio.5mp.eu
Ha tudnám ki hozta létre, hátbaveregetném, köszönetem jeléűl.
Benyovszky Gábor
Sziasztok.
A címben szereplő R-erősítőbe kellene egy trafó. A primer oldal szakadt, és nehezen pótolható mert a szek-oldal tele van különböző feszekkel. :( Még nem próbáltam szétszedni javítani, de nem sok reményt látok mert nagyon be van öntve. Ha valaki már csinálta akkor adjon egy lökést, lehet?
Köszi előre is.
Szép estét.
Sziasztok!
Ebbe az erôsítôbe elment az STK463 2x25W Unom ±26V Umax±38V, mivel mostmár nem 220V van ezért a maximumon ±37.5V on van hajtva az STK.
Nekem van STK460-om ezt szeretném betenni Unom±23V Umax±32V 2x20W.
Le kellene vennem kb ±10V-ot, mivel birnam ezt olcsón megoldanom ?
(7824/7924 nem jó erre mert rövidzárvédettek. Trafónak csak egy primerje van, szekundert nem lehet letekerni).
I have a Yamaha CDX-590 CD player and it skips on some CDs - original CDs, these CDs play without problems on my other CD players.
I have changed the laser unit (KSS-210A) but this didn't solve the problem.
When I turn the player upside down, it plays the problematic CDs without a problem.
That's why I think the laser needs adjustment.
I have only a service manual for the CDX-493/593 but they should be very similar to the CDX-590.
It seems that the adjustments are done via "test mode" of the CDX-590, unfortunately there is not much information, how to exactly, in the service manual.
Here is a picture of the PCB.
http://www.volny.cz/hwtest/PCB.JPG
Here are the "test mode" sections of the service manual.
http://www.volny.cz/hwtest/TM1.GIF
http://www.volny.cz/hwtest/TM2.GIF
In "test mode" I have tried Auto adjustment mode 1, 2, 3, but I don't know if it should work fully automatic without any intervention or when the mode is fineshed and I can proceed to the next one.
So I activated mode 1, waited a while, activated mode 2, waited a while, activated mode 3, then exited test mode.
It didn't help.
Mode 1 - only a short blink of two horizontal dashes on the display and thats it
Mode 2 - started "play" without sound from a strange time 99:00 (the test CD is not so long), after a while it skips to another time, "plays" a while, then skips back and "plays" and so on, I left it about an hour and it was still going on
Mode 3 - seems to be very short as mode 1
I think I'm missing something ...
Maybe someone did this or even serviced Yamahas in an official service and can provide information how to adjust the laser?
Or maybe the problem is not the laser?