SONY AE1 sasszi képhibák:

-NO PIC EXCEPT ON AV CHAN ALL PROGS SET TO EXT IN PRESET MEMORY - IN SERVICE MODE SET TO INIT BYTE			-INT PIC WHEN OFF TURNING UP A1 GIVES PIC WITH NO B - B O/P TR Q709 DRY JOINT
-INT PICTURE , TOUCHING / ADJUSTING A1 BRINGS PICTU CHECK FOR DRYS ON TEXT PCB , PARTICULARLY ON TOP MOUNTED PLUGS / SOCKETS
-BLANK RASTER WITH FLYBACK LINES, R805 (1R2)
-INT LUMINANCE  DELAY LINE DL332 ON PCB B, PART NO IS 1-236-062
-NO PIC NO A1'S D803,R807,R812				
-NO PICTURE - SOUND OK. MOD.				
-NO PICTURE - WITH SOUND. D803 , R807(1K)				
-NO SND/PIC, L606 Q608, Q805. R822 1K OHM 1W,
-NO SOUND OR PIC 12V AT L606 LOW R822(1K)
-PIC BLANKED OUT - SOUND OK CHECK 18V SUPPLY - READ 38V.; Q608 2SD1761
-PICTURE COVERED BY FINE SHIMMERING HORIZONTAL BLAC R544 330R IN FIELD CCT
-PICTURE DISSAPEARS AND GOES TO SNOW CHECK MEMORY IC FOR-30V , IF LOW CHECK L807 10UH
-SLOW PIC, C615 1000UF, 25V.				
-SLOW+NEG PIC, HT LOW AT 120V(135VN) C516(1000UF25V)
-HI HT, 135VN. R522 100K		
-PIC INT BLANKS OUT COMES ON WITH TAPPING ON REAR PANEL Q1404 FAULTY						
-BLANK RASTER Q305 DTA144EK ON DECODER BOARD B		-NO PIC IC301(TDA4580)
-NO PIC - SOUND OK WHEN A1S ADVANCED GREEN PIC APPEARED TDA4580 IC301						
-NO RASTER. TDA4580 COLOUR SIGNAL PROCESSOR CHIP IC301,		-PIC CUTS OUT AFT 5 MINS WITH CLICK FROM SPKRS OK IN STBY IC604 7605 5V REG							
-PIC FLICKS FROM COLOUR TO B/W 5V SUPPLY ON B BOARD MISSING CIRCUIT PROTECTOR
-PIC INT COL AND BLANKS OUT INT DRY JOINTS ON VID PROCESS VERT PCB - EARTH LANDS OF SCREENING CAN