Üdvözlet!
A videokamera miniDV szalagos, és amikor rögzítek és visszajászok magán a kamerán és az analóg kimenetén látható az adatkódolás, mármint a felvétel dátuma és ideje, viszont amikor rámásolom firevire kábellel és kártyával számítógépre, nem tudom sehogy megjeleníteni! (ez a tipikus dátum idő megjelenítés ami a klasszikus kamerafelvételeken látható)
van a menüben egy olyan beállítási lehetőség hogy adatkód és akár be vagy ki van kapcsolva sehogy se látszik a szgépen, csak a kamerán.
ötlet?
köszönettel Döme Attila
Hi friends,
I would like to make adjustments to my Sony DSC-F717.
According to service manual, the service remote is attached via CPC jig, where a 2,5mm LANC port is mounted. I'd like to DIY a improvised jig.
Exact detail of the jig is not provided, but clearly it is a 22-pin FPC splited into many measure points and a LANC port. Also learned from the manual that LANC signal to/from CPC is splited into 2 lanes, IN and OUT, while 2,5mm LANC port only has 1 (bidirectional) data bus. I wonder if these 2 signals are mixed by additional circuits on the jig.
If someone can post a back (trace-side) photo of CPC12, the mystery will be solved and it will be much appreciated, thanks in advance!
Sziasztok!
Olyan gondom lenne a fent nevezett készülékkel, hogy amikor felvételt készítek akkor szakadozik a hang, ill. pixeles lesz a felvétel. De csak akkor ha a kamerát mozgatom ha egy pontra nézek vele akkor nem.
Mi lehet ez?
Üdv Sanyi
Sziasztok!
Van egy Sony DCR-SR 72A kamerám. Tegnap elővettem és ezt a hibaüzenetet kaptam:
"HDD Format Error" E:31:00 Elég rég használtam, de mikor eltettem teljesen jól működött. Fel lehet ezt valahogy éleszteni, vagy HDD-t kell benne cserélni?
A Win. intézőben a gép betűjele megjelenik, de semmi tartalom. A Hard Disk Sentinel-el szintén megjelenik a betűjele, de nem látja a HDD-t, az összes eredmény kérdőjeles.
rittzo