Sziasztok
SONY CCD-TRV46E kamerához keresek rajzot.Probléma az, hogy erősebb fényben túl vezérlődik.Az optikában van egy kis motor ami két kis ajtóval szabályozza a beérkező fényt ezek letörtek.
Köszönöm előre is a segítságet.
Sziasztok a fent említett kamera miért szakítja el a szalagot a tekerés végén illetve ha a végén van akkor behelyezés után?
Már 3x ragasztottam meg a kazettát.
Üdv Gabee.
Sziasztok!
Sony service manualt keresek CCU-D50P vezérlőhöz és a CA-D50P kamera dokkhoz, segítségeteket kérem a témához.
Köszi Imre
Hi friends,
I would like to make adjustments to my Sony DSC-F717.
According to service manual, the service remote is attached via CPC jig, where a 2,5mm LANC port is mounted. I'd like to DIY a improvised jig.
Exact detail of the jig is not provided, but clearly it is a 22-pin FPC splited into many measure points and a LANC port. Also learned from the manual that LANC signal to/from CPC is splited into 2 lanes, IN and OUT, while 2,5mm LANC port only has 1 (bidirectional) data bus. I wonder if these 2 signals are mixed by additional circuits on the jig.
If someone can post a back (trace-side) photo of CPC12, the mystery will be solved and it will be much appreciated, thanks in advance!