Sziasztok
Ennek a tv-nek ossze van karcolva ,szakitva a hatuljan az iras.Ha tudtok segitsetek beazonositani,elore is koszonom!
Sziasztok tudna e nekem valaki segíteni
Panasonic TX-29M CP-521F táp problémám van kicsi a táp 106 V van 131 V helyet
Táp IC primer elkok cserélve opto DP 130 cserélve ötlete van e valakinek előre is kösz
Tibor
Hello!
A fenti készülékkel a következő a helyzet rádugott fogyasztás-mérővel:
Bekapcsolt készüléknél 150-260W, készenléti üzemnél 66-68W, kikapcsolt főkapcsolóval 55W-ot mutat a mérő. Ha beiktatok egy billenőkapcsolós hosszabbítót és kikapcsolom, 0W-ot mutat. Nem értem ezt a jelenséget, tudna valaki segíteni? Normális ez így?
This elderly monster arrived with the error “ 4 blinks “ which the manual suggests is a power board fault
There are TWO power boards and a standby power board inside
On removing rear cover there were two swollen 220uf caps on the standby board, sadly replacing them the 4 blinks remained
Swapping the two power boards over[ as they look identical , gives a “ 2 Blink “ error , the limited info in the manual suggesting that the fault is on the lower board [ main 2 ]
Both boards have a PFC voltage of around 380 volts at switch on before the relays click out
I have done cold checks on both boards and there are no obvious differences
As the manual has only a block diagram of the power supply it’s difficult to be sure of values / voltages
Has anybody seen or worked one of these or similar beasts and managed to diagnose the problem
Thanks for looking
Regards Ken