Keresem a címben említett tv valamilyen eprom mentését, bin file,flash, firmware,vagy más egyéb formában. Vagy esetleg egy mentés is jól jönne egy működő típusból. Előre is köszönöm.
Hi to all forum participants.
I have a TP.MS3463S.P801 board with power supply dead shorted. Among the burnt component there is a small 1x0.5mm SMD resistor (named as RB105). This resistor is on the current sensing circuit of the IC controller (an LD7530). I would like to ask you the courtesy if someone could provide me the value of the RB105 which is not shown in the circuit diagram of the board (the same is the value of all other components). The the resistor hasn't any value printed on top and I am afraid that without the correct value, the power supply could not function properly. I found the SM in the download section. Thank you in advance.
Attached the photo with the burnt resistor..
Üdv!
Siemens FS 236 V6 ------- CS9111-Sassye táp hiba. Ugy került ide a tv ,hogy st by led világít,és tök némaság mindenütt távval sem indult,sem gombokkal..Párszor ki be kapcsolgattam,kis pukkanás,és a led sem világit már.Fet zárlatos lett,kicseréltem,és ugyanaz a szitu nem áll fel a st by sem.ami eddig meg volt,igaz akkor melegedett a fet kissé....Mi ami ez esetben ennél a sassyenál kritikus dolog a tápban,amit cserélni illik vagy meg kéne nézzek??
Köszi előre is!
Üdv:Spar
Szevasztok!
Van nálam egy ilyen készülék,amiben az impulzus kondik elszenesedtek úgy ,hogy a környezete is meg az alaplap is.
Lenne-e valakinek egy alaplap,amiben meg tudnánk egyezni?
Üdv.,feri.