Sziasztok!
A saját nyomtatómmal kínlódok. Általában feketét nyomtatok,néha színeset,hogy be ne száradjon.Ma használnám a nyomtatót,a sárga led 5 villanás a zöld 1.A leírás szerint patron probléma.A feketét cseréltem,mert volt egy zsír új,de továbbra sem működik. Színeset nem szívesen vennék,mert elég drága.Mit lehet tenni,hogy működésre bírjam?
Köszönettel:pulo
Sziasztok
Adott egy IR1600 nagydarab dög. Az ajtó nyitva hibaüzenet miatt nem csinál semmit. Találtam benne az első az oldalsó ajtónál kapcsolót amik biztosan jók mert lenyitás visszacsukás után teszt elindul de a hiba üzenet megjelenik újra. A tetején lévő szkener fedél 2 optó érzékelőjét kimértem jók. belső elem jó. resetelés a szervízmenüben megtörtént. Mi lehet a baja? Esetleg szervízrajza valakinek, hogy a panelen ellenőrizhessem a szenzorok állapotát.
Köszönettel Laci
Sziasztok!
Ismerős kérdezett, hogy egy ilyen hibajelzést ír ki a gép és nem hajlandó nyomtatni, gondolom itt nem elég a fizikai tisztítás, szoftveresen hogyan lehet alaphelyzetbe állítani a gépet miután a tisztítás megtörtént?
MP360-ál, az "i" sorozatnál egy progit kell tenni a gépre, de erre nincs infóm.
Üdv mesterek. A fent emlitett nyomda az enyém. Már talán egy hónapja is van annak, hogy kifogytak a festékpatronok,,40 és 41,,. Vettem is bele de a szines helyett nem originált hanem kinait. Eddig műkődőttis rendben csak a szines patron tartalmát nemjelezte, ami nemnagyon zavart. De most megmakacsolta magát és hiába minden még feketén se nyomtat. Azt irja ki, hogy a szines patron ismeretlen és nemnyomtat. Tudnátok rajtam segiteni? Kilehet valahogy játszani hogy elfogadja a szines patronomat is?