Service manuals, schematics, eproms for electrical technicians
DTJ-28G6F 2416
Type: 
(E2P)
(E2P)Size
2.1 KB
2.1 KB
Page
---
---
Category
TV
EPROM
TV
EPROM
If you get stuck in repairing a defective appliance download this repair information for help. See below.
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar dtj manual?
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar dtj manual?
Document preview [1st page]
No preview item for this file.
Possible causes:
- No preview picture generated yet.
- It is not a pdf file.
Advertisements
Please tick the box below to get download link:
- Also known:
DTJ-28G-6F DTJ28G6F 2416 DTJ 28 28G6F DTJ-28G6F
- If you have any question about repairing write your question to the Message board. For this no need registration.
- If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site.
Have a nice Day! - See related repair forum topics below. May be help you to repair.
Warning!
If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
Note! To open downloaded files you need acrobat reader or similar pdf reader program. In addition,
some files are archived,If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
Translate this page:
Relevant TV forum topics:
Sziasztok!
Az alábbi hibajelenséghez kérném a segítségeteket:
Készenlétben túl nagy feszültségek vannak a táp szekunder oldalán, kétszerese az üzemi feszültségeknek pl: sorvég felé 142V helyett 190V, ill. halk sípolás hallható.
Ha készenlétből bekapcsolom akkor működik, minden feszültség rendben van.
C820 pozíciójú 3300uF 16V-os kondi ki volt száradva (1000uF) azt cseréltem.
Valamint az összes elkót, az X0202DA tirisztort ami ha jól értelmezem a kaprajzot pontosan arra lenne hivatott, hogy rendes készenléti állapotot fönnálljon.
Cseréltem még az SE140N söntstabilizátort is de változás nincs.
Ha lenne ötletetek írjatok.
Köszönöm: Laci