Üdv Mindenkinek!
Ha valakit érdekel tudatom, hogy ismét kapható a fenti univerzális (+tanítható) távirányító a LIDL-ben 2.200 pénzért.
Üdv: Laci
Üdv! Érdeklődök valaki telepített már ilyet?
http://mikster.eu/products/controllers/control-of-smoke-curing-and-scalding-chambers-en/mcc-026-microprocessor-controller-2/
Lengyel gyártmány, természetesen magyar leírás nincs. Angol van, de nem elég részletes vagy egyértelmű számomra. Az egy programon belüli idő beállítása nem egyértelmű, A time step gondolom a beállítható 6 step/lépést váltja, de ezen belül mi a két time phase? Hőmérsékletet és páratartalmat kellene szabályoznia több lépésben. (fűtést kapcsolna ill. ventilátort ki/be/irányváltást)
Van valakinek magyar leírása ill állított már be ilyet?
Tápja 24V AC, PT100 a hőérzékelő, a páratartalmat szabványos 4-20mA jelet adó érzékelő méri, a kimenetek relék.
próbáltam PC-vel is összehozni, hátha ott könnyebb beállítani. Adtak hozzá CD-t programmal, amit feltelepítve fut, de nincs kapcsolat a szabályzóval. A szabályzón RS-232-es csati van: bekötés(lábak): 3 - TDX, 5- GND, 6 - DSR felirattal a szabályzón. Nem tudom kompatibilis e, egy nullmodem kábel egyik végén átkötöttem a 2-es lábat a 6-osra, mert alapból a 2-es és 3-as lába van keresztbe kötve benne, de nem működik. Lehet, hogy hülyeséget csináltam?
Üdv!
A fenti masina szervizelésével bízott meg egy jó barátom. A " hálón " különösebb infót nem találtam. Ha valaki javított ilyet, illetve tud alkatrész beszerzési (itthoni) kérem jelezze. Mi lehet az elsődleges probléma? Köszönöm!
Sziasztok.
Egyik volt kollégánk bioptron lámpáját javítom.
A tápja már megy de elhalálozott a mikrovezérlő a vezérlő paneljén a programmal együtt.
Egy pic16c54 volt benne PKLAMP1.0 felirattal.
Ha esetleg valakinek meglenne a programja vagy bármi megoldás hozzá hogy hogyan tudnám feléleszteni a vezérlőjét nagyon hálás lennék érte.
Köszönöm előre is.