Sziasztok!
Keresem a fenti VCR rajzát. Szétesett a fejtrafó, ki voltak száradva a tápelkók. Javítás után minden működik, csak a szalagvégeket nem érzékeli. Az IR LED világít és diódamérővel az IR vevők jónak tűnnek. Ha letakarom lezárnak, ha belevilágít az adó LED, akkor kinyitnak (kb. 700mV). Bekötve viszont állandóan 0V mérhető rajta. Próbáltam végigkövetni a vezetékeket, de nem értem, mert egy-egy 33kOHM-on a syscon prociba mennek. Mitől lesz ott értelmes feszültség? Lehet, hogy belül a proci huzná fel tápra? De mind a két bemenet egyformán rossz lenne? Szóval jól jönne egy rajz erről a részről.
Edmundson
Sziasztok!
Bocsánat, de ismét lenne egy kérésem.
A fenti videóhoz kellene nekem kapcsolási rajz, de sehol nem találok.
Ha esetleg lenne valakinek, nagyon megköszönném.
Laci
Viedeórendszerhez keresek Intercom kapcsolási rajzot és ötleteket
3 kamera és a videókeverő közé, mindenki halljon mindenkit és beszélni is tudjon ,ha kell szelektálni is lehessen
szevasztok!
van egy dalton dvd lejátszóm keresnék hozzá
egy távirányítót.
Ha valaki tud sgiteni kérem tegye meg.
Előre is köszi.
lacika1