Hi,
unfortunately the LCD Screen of my Panasonic HVX200 broke.
Now I am trying to search a replacement screen.
The part number of the LCD is LTA035D050A. I've already enquired utsource.com and invertercentral.com but the LCD is nowhere in stock.
I have already found out that it's probably produced by Toshiba.
The A in LTA perhaps stands for Automotive (just a guess!)
The 035 stand for 3.5 inches.
Does anyone have an idea where to obtain this part?
Thank you very much!
Alex
Üdvözletem a Tanyásoknak!
Adva vagyon egy Panasonic NV-DS65EG digitális videó kamera. Precízen műanyag pufi fóliába betekerve az esetleges sérülések elkerülése érdekében.Egyik nap előveszem a kamerát és nem működik,mert pára lecsapódás hibával rögtön ki is kapcsolódik.A következő kérdéseim lennének:Voltak e már hasonló problémáitok? Mi a hiba megoldása? Mi érzékeli a pára lecsapódást a kamerában.Okozhat e ilyen hibát a műanyag pufi fólia.A válaszotokat várva és előre megköszönve
Pistili
Sziasztok!
Van egy Panasonic DMZ FZ20 digitális fényképező gépem,nem nagyon használom mert rossz az akksija,de jópár képet tudok vele csinálni ha muszáj,most olyan probléma lett vele hogy elővettem és a gombok nem működnek,így használni nem tudom,fizikai sérülés nem érte,mikor eltettem a tokjába kb 1 éve még működött.Ha valakinek volt már hasonló problémája vagy tudna segíteni nagyon megköszönném,mert sajnos ez a hiba most feladta a leckét.
initialy the GH5 viewfinder (LVF) would not display anything when I looked through it, indicating a possible issue with the power supply or the internal connection to the viewfinder circuit. So i Opened the camera and inspected the flexible ribbon cable connected to the viewfinder PCB.
-
Identified a potential problem with the FPC connector, which appeared loose and damaged at the pin connection points.But i resolder it.
-
And i Tested the continuity of key components the power board,even the flex cable by cotinuity.
-
After that, testing, the device did not power on at all, even after check the ribbon cable and ensuring the battery was functional.i have 3 diffrents.
-
Currently i'm thinking on check if the power board (DC-in connector) has a short circuit or other internal faults that might have caused the system failure
Does someone can confirm which part i have to test and which component maybe ?
Can anyone confirm which specific components I should test further?
Thank you!