Üdv!
Keresek bontásból Panasonic TX-29PM1P típusú, CP-521F sassziba sorkimenőt, hát ha akad valakinél felesleges. Az utángyártottja a HR80306 vagy az FBT41280. Köszi előre is! Jani
Hi
I am having trouble finding any information regarding this product.
The unit powers up and the output is displayed on the screen for between 0 and ten seconds, the unit then powers down, the red standby LED on the front of the unit blinks then remains off for 5 seconds then blinks again.
This cycle continues until the power is disconnected, if the power is reconnected the unit goes back in to stand by (red led steady) it will then power on again.
Also in the error mode (red led blinking) and the power button on the back of the unit is pressed twice it will power up but this does not happen if the remote is used.
I have tested various capacitors and diodes but all seems well, I have also replaced the power supply with a reconditioned unit but this has not helped.
I have been unable to obtain any service information for this product.
So any input would be most helpful.
Thank you
Stephen Fry
Sziasztok!
A címben szereplő Panasonic ki-be kapcsolgat,de képet nem produkál.Valami zárlat lehet benne,de mi?
A képeltérítő ic la7876n van benne, csinálhat e ilyen hibát?A sorkimenő szerintem jó ,mert ha kikapcsolom,ki kell sütni mert fel van töltődve.A készülék helyszínen van,mert a tömege közelíti a 100kg-t ezért szeretném helyben meg-
javítani.A SEGÍTSÉGET előre is köszönöm!
Sziasztok!
Ebbe a készülékbe futottam bele, beindulna de kikapcsol készenlétbe, és villog a led. Ki volt rohadva a függőleges eltérítő ic, de ezután is ez maradt a hiba. Kivéve a sorvégtranzisztort, a fő táp csak 75V, és többször indul és leáll a táp. Ekkor a tápfeszeim 20V, 15V, 3V és 75V, cseréltem 2db 100uf kondit a primer körben, zárlatos diódát nem találtam, Mi lehet a táp ic, vagy valamelyik optó? Előre is köszönök minden segítséget!