Udv es boldog Uj evet mindenkinek!Volna egy Panasonic TX32LE7P/SA,GLP21MA sasszi,amellik egy halozati lorugas eredmenyekent bedoglott.MR4040 totalkaros,puffer kondi kinyilt mint a tubarozsa.Ezeken kivul minden OK(?).Csere utan uresben tap indul de terhelessel ledoglik.Ha egy ideig pihen a draga inditaskor pillog zolden a st.by led majd megjelenik a kep de villog,majd st.by,azutan ujra pillog zolden a st.by majd megjelenik a kep villogva.Ha ezt tobszor eljatszom a tap ledoglik,se te piros se te zold st.by led, csak halk tucsokzene a tap felol.Na ezt adja ossze valaki es huzon ki a slamasztikabol!!Elore is koszonok minden hozzaszolast!!
Tiszteletem a Tanya szorgos tagjainak!
Adott, egy TX-29AD10F készülék, melynek, A68ESF002X43 képcsövéből, eltűnt a kék szín. (Katód potenciál, nem érdekli)! Nem nagyon fűlik a fogam a cseréjéhez, de a tulaj szeretné megjavíttatni. Keresek, valamilyen beszerzési forrást, az említett képcsőhöz, ármegjelöléssel.
Válaszaitokat előre is köszönöm:
exGelkás
Picit bővítettem.
Kalex
Hi
I am having trouble finding any information regarding this product.
The unit powers up and the output is displayed on the screen for between 0 and ten seconds, the unit then powers down, the red standby LED on the front of the unit blinks then remains off for 5 seconds then blinks again.
This cycle continues until the power is disconnected, if the power is reconnected the unit goes back in to stand by (red led steady) it will then power on again.
Also in the error mode (red led blinking) and the power button on the back of the unit is pressed twice it will power up but this does not happen if the remote is used.
I have tested various capacitors and diodes but all seems well, I have also replaced the power supply with a reconditioned unit but this has not helped.
I have been unable to obtain any service information for this product.
So any input would be most helpful.
Thank you
Stephen Fry
Űdv Mindenkinek !!!!
Kűzdök ezzel a készülékkel,hibajelenség a következő:
-stdby ok ,bekapcsoláskor átvált zöldre a led de a szokványostól gyorsabban pislog mig teljesen zöld lessz,, távira reagál bekapcsool, de nem tudom kikapcsolni stdby-ba
- invertert nem inditja még egy villanás erejéig sem,tettem antennát és hang sincs..
- ha járatom,kb 10 perc után kattan a relé 1-2er, 2-3 perc mulva piros led 13-as hibakódot jelez.
A táp mérve jónak tűnik a feszkók megvannak,én a mainboard-ra tippelek..
az eservice-ről letöltöttem a SM-t csak sajnos nem tudom megnyitni..
minden segitséget eőre is köszönök
gyurmonc