Sziasztok tudna e nekem valaki segíteni
Panasonic TX-29M CP-521F táp problémám van kicsi a táp 106 V van 131 V helyet
Táp IC primer elkok cserélve opto DP 130 cserélve ötlete van e valakinek előre is kösz
Tibor
Üdv. Mindenkinek.
Pana,TX21JT2C tip. Ch: Z-M3L masinával küzdök. Nincs hangja.
Proc mutte lába, így a hangvég mutte lába 0V.
Proc 62 láb felhúzó ell.nem szakadt, ohmikusan nincs a földön.
A végfok sem. A végfokon minden fesz. stimmel, kivéve a 9-es (mutte)
Szoftver hiba? Memót még nem cseréltem (smd)
Tippeitek?? Köszönettel.
Hi
I am having trouble finding any information regarding this product.
The unit powers up and the output is displayed on the screen for between 0 and ten seconds, the unit then powers down, the red standby LED on the front of the unit blinks then remains off for 5 seconds then blinks again.
This cycle continues until the power is disconnected, if the power is reconnected the unit goes back in to stand by (red led steady) it will then power on again.
Also in the error mode (red led blinking) and the power button on the back of the unit is pressed twice it will power up but this does not happen if the remote is used.
I have tested various capacitors and diodes but all seems well, I have also replaced the power supply with a reconditioned unit but this has not helped.
I have been unable to obtain any service information for this product.
So any input would be most helpful.
Thank you
Stephen Fry
Helló!
A tulaj addig nyomkodta bele az sd kártyát míg ide nem jutott a készülék. Sztetek biztosan main cserés, vagy elképzelhehtő, hogy lehet vhogy resetálni a lapot? A készülék nem is indul és úgy tudom, hogy a resethez le kellene indulnia. Ha csak simán beindítom a tápot akkor nem lehet vhogy resetálni?
Üdv.: Ízirájder