Sziasztok a fent említett kamera miért szakítja el a szalagot a tekerés végén illetve ha a végén van akkor behelyezés után?
Már 3x ragasztottam meg a kazettát.
Üdv Gabee.
Hi friends,
I would like to make adjustments to my Sony DSC-F717.
According to service manual, the service remote is attached via CPC jig, where a 2,5mm LANC port is mounted. I'd like to DIY a improvised jig.
Exact detail of the jig is not provided, but clearly it is a 22-pin FPC splited into many measure points and a LANC port. Also learned from the manual that LANC signal to/from CPC is splited into 2 lanes, IN and OUT, while 2,5mm LANC port only has 1 (bidirectional) data bus. I wonder if these 2 signals are mixed by additional circuits on the jig.
If someone can post a back (trace-side) photo of CPC12, the mystery will be solved and it will be much appreciated, thanks in advance!
Üdvözlök minden kollégát!
Érkezett hozzám egy fényképező amit elszúrtak a szoftwer frissítéssel.Most bekapcsoló gombra csak annyit reagál hogy az áramfelvétele kb 200mA-ra emelkedik és innen sehova tovább.Ilyenkor van valami hardweres mód amivel helyre lehet hozni egy ilyen baklövést? Service manuáljában olvastam hogy a memóriakártyára másolt szoftwerrel frissíthető. Innen lehetne letölteni: https://denhin.fujifilm.co.jp/csg_en/index.htm. A YJ01169-100.zip file kellene. Persze csak jelszóval engedne be....
Esetleg valakinek meg van vagy tudna valami megoldást hogyan lehetne a sz*rt visszalapátolni a lóba?? :)
Üdv!
Sziasztok!
Van egy Toshiba PX1333E-1CAM kamerám, ami semmit nem csinál. Tudna-e valaki rajzzal, vagy egyébbel segíteni? Jó néhány más gépet már megjavítottam mechanika és elektromos hibával, de itt elakadtam.
Köszönettel
Attila