Service manuals, schematics, eproms for electrical technicians
SONY200GST
Type: 
(ZIP)
(ZIP)Size
704.0byte
704.0byte
Page
---
---
Category
MONITOR
EPROM
MONITOR
EPROM
If you get stuck in repairing a defective appliance download this repair information for help. See below.
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar sony manual?
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar sony manual?
Document preview [1st page]
No preview item for this file.
Possible causes:
- No preview picture generated yet.
- It is not a pdf file.
Advertisements
Please tick the box below to get download link:
- Also known:
SONY200GST SONY 200 GST
- If you have any question about repairing write your question to the Message board. For this no need registration.
- If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site.
Have a nice Day! - See related repair forum topics below. May be help you to repair.
Warning!
If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
Note! To open downloaded files you need acrobat reader or similar pdf reader program. In addition,
some files are archived,If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
Translate this page:
Relevant MONITOR forum topics:
Szisztok!
Pupos tápkondik,sistergés a bekapcsoláskor.
Ez volt a panaszolt hiba- táp javítva, másik csövek rádugva kétszer indít kb.3sec.-ig van kép, fény, majd a fény eltűnik.A készülék bekapcsolva marad.
Az inverter trafók egyformák, jelalkok a kimeneten jók ,egyformák.
Ehhez kérnék segítséget.
Köszönettel : Laci
Sziasztok ehez a monitorhoz keresek rajzot,ha van valakinek valami tippje szivesen fogadom!!!Előre is köszönöm!!
Helló ! Kukáztam egy Tatung VM-9AF kis monitort. 9"-os monokróm SVGA. Az az ötletem támadt, hogy kompozit kamera videojelét szeretném belevinni úgy, hogy a képernyőn az meg is jelenjen. Lehetséges-e ez max. pár tranzisztorral vagy nem ? Előre bocsátom, hogy nem szeretnék venni és pénzem sincs külső kompozitból-VGA-ra alakító céláramkörre. A kis monitor amúgy sem ér ennyit. Tehát, megoldható-e pár tranzisztorból a dolog (vagy egyszerűbben persze). Rajzot tettem fel ide az Elektrotanyára. Köszi a segítséget.
This unit has no HDMI output , the audio is OK, the fault occurred after the lamp failed in the projector this unit was connected to ,
Have tried doing a factory reset , no change
Has anyone experience of this please ?
Regards
Ken
Have tried doing a factory reset , no change
Has anyone experience of this please ?
Regards
Ken