Translate this page:

I'm new to these forums and don't speak Hungarian.

I found a partial service manual for Sony SELP1650 lens (the exploded diagram, and instructions for removing the focusing barrel).

Please could this be added to your service manuals download section.

Thanks for providing forum, and resources.

Sziasztok! Segítségeteket szeretném kérni egy SONY handycam DCRSR35 ben lévő 1.8" merevlemez mentésével kapcsolatban. Az említett kamera medencébe esett, elázott szerencsére nem volt bekapcsolva mégis ki tisztítás után nem kapcsolódik be. A benne lévő TOSHIBA 1.8" MK6014GAL típusú merevlemezről kellene a filmeket, képeket lementeni. A gond az hogy mivel a kamera nem működik nem tudom mihez kapcsolni megfelelő kábel és eszköz hiányában. A meghajtónak ATA-4 interfésze van. Ki tud esetleg átalakítot vagy eszközt a HDD csatlakozásához, esetleg mentéséhez? Szalagkábel csatlakozású Előre is Kösz Üdv. Gábor

Hi friends,

I would like to make adjustments to my Sony DSC-F717.

According to service manual, the service remote is attached via CPC jig, where a 2,5mm LANC port is mounted. I'd like to DIY a improvised jig.
Exact detail of the jig is not provided, but clearly it is a 22-pin FPC splited into many measure points and a LANC port. Also learned from the manual that LANC signal to/from CPC is splited into 2 lanes, IN and OUT, while 2,5mm LANC port only has 1 (bidirectional) data bus. I wonder if these 2 signals are mixed by additional circuits on the jig.

If someone can post a back (trace-side) photo of CPC12, the mystery will be solved and it will be much appreciated, thanks in advance!

Hi everyone,

Could somebody tell me how I can get (or buy) the Sony AdjustStation with the adjustment manual for my old Sony A55V camera? Recently, the IBIS died in this camera, and after some time the shutter died too. This rendered the camera completely unusable. Since the camera is quite old, no repair shop near me was willing to fix it at a reasonable price. So I bought the shutter unit and IBIS on AliExpress and successfully swapped them. The problem now is that the shutter is clearly misaligned. The service manual says that after replacing the shutter and IBIS, they must be calibrated to work properly. According to the manual, AdjustStation software is required for that. The camera is very important to me as it holds many memories, so I’m determined to get it working again.