Translate this page:

Hello, 

recently bought this lens as "broken/for parts" item. After inspection found there is missing FPC cable, bought one from Aliexpess. Installed it, still not working. After long searching in google was able to find a repair video, that there is seen for a while that there is something with 2-wires in the slot, that is in the photos.  

Here is video at the moment that the part can be seen: https://youtu.be/PjEBGFLjgM0?t=410 (from about 6:50 mins). At 10:44 is seen that the part is only in the bottom side of the slot; and nothing more detailed in the whole internet that I was able to check for about a hour. 

There is magnetic field sensor - top left on the DSC07181 and on the next photo fitted on its place, so I think it should be some kind of tiny end position switch or don't know what;

any help as service manual, photo or part number will be in help.


Regards,

Milen

Üdv Mindenkinek! Ha nem velem történik, el sem hiszem! Kaptam egy használt kazettát, és miután betettem, újra kiadta. Ekkor nyitottam ki, és láttam, hogy a szalag totál gyűrött... Ezután viszont a saját kazettáimat sem játszotta le. :) Két fej kitörött. Szóval videófej csere a megoldás, amihez kérem a segítségeteket. ( beszerzési forrás, otthon panelhibával, vagy mechanikai hibával porosodó készülékből kimenthető fej...) Kérlek. ha tudtok segítsetek! A gond nálam is az anyagiak hiánya,és szeretném viszonylag olcsón újra működőképessé tenni. Tudom, kifutott technika, de az évek óta felvett kazetták digitalizálásához nagy segítség lenne. Köszönettel: FEJO Fejcsere után újra működik... :)

Hi friends,

I would like to make adjustments to my Sony DSC-F717.

According to service manual, the service remote is attached via CPC jig, where a 2,5mm LANC port is mounted. I'd like to DIY a improvised jig.
Exact detail of the jig is not provided, but clearly it is a 22-pin FPC splited into many measure points and a LANC port. Also learned from the manual that LANC signal to/from CPC is splited into 2 lanes, IN and OUT, while 2,5mm LANC port only has 1 (bidirectional) data bus. I wonder if these 2 signals are mixed by additional circuits on the jig.

If someone can post a back (trace-side) photo of CPC12, the mystery will be solved and it will be much appreciated, thanks in advance!

Hi everyone,

Could somebody tell me how I can get (or buy) the Sony AdjustStation with the adjustment manual for my old Sony A55V camera? Recently, the IBIS died in this camera, and after some time the shutter died too. This rendered the camera completely unusable. Since the camera is quite old, no repair shop near me was willing to fix it at a reasonable price. So I bought the shutter unit and IBIS on AliExpress and successfully swapped them. The problem now is that the shutter is clearly misaligned. The service manual says that after replacing the shutter and IBIS, they must be calibrated to work properly. According to the manual, AdjustStation software is required for that. The camera is very important to me as it holds many memories, so I’m determined to get it working again.