Service manuals, schematics, eproms for electrical technicians
THERMO-FEG MV4 VIZMELEGITO KEZELESI UTMUTATO
Type: 
(PDF)
(PDF)Size
106.7 KB
106.7 KB
Page
8
8
Category
OTHER
USER MANUAL
OTHER
USER MANUAL
If you get stuck in repairing a defective appliance download this repair information for help. See below.
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar thermo manual?
Good luck to the repair!
Please do not offer the downloaded file for sell only use it for personal usage!
Looking for similar thermo manual?
Advertisements
Document preview [1st page]
Click on the link for free download!
Document preview [2nd page]
Click on the link for free download!
Advertisements
Please tick the box below to get download link:
- Also known:
THERMOFEG MV-4 KEZELESI UTMUTATO MV4 MV THERMO FEG THERMO-FEG
- If you have any question about repairing write your question to the Message board. For this no need registration.
- If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site.
Have a nice Day! - See related repair forum topics below. May be help you to repair.
Warning!
If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
Note! To open downloaded files you need acrobat reader or similar pdf reader program. In addition,
some files are archived,If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!
so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
Translate this page:
Relevant OTHER forum topics:
Sziastok!
Van egy Computherm q7RF thermostatom, de nem egészen úgy viselkedik, ahogy kellene. A vevőben elfáradt egy 330nF 275V X2 kondi a tápban, csere után feléledt. Az összes elkót is cseréltem, de még mindig furán viselkedik.
Az adót nem látja a vevő.
Erre írja a leírás, hogy a vevőn 10sec időtartamra az M/A gombócot nyomva kell tartani, amíg a LED zölden nem villog, majd az adón a SET, és DAY gombot 10sec időtartamra nyomva tartva új azonosítót generál, és párosodnak..
Nos, nálam ha a vevőnek tápot adok, a zöld villog magától. Ha röviden megnyomom az M/A gombot, a LED nem villog, világít. 10sec nyomvatartás mellett nem történik semmi, a relét manuálisan ki tudom vezérelni, ekkor a piros LED világít.
Olyan, mint ha a leírás, ami mindenhol megtalálható, és "új software" feliratú, az nem lenne ehhez jó, vagy valami még szivat..
Ismeri valaki ezt a szerkezetet? 2007-ben szögeltem fel a falra...
http://www.quantrax.hu/userfiles/file/hu/Q7RF_hu.pdf
Köszönöm!