A monitor bekapcsolható, de nincs kép, a monitor menűje sem jeleníthető meg. A feszültségek a Power Board-on rendben vannak, van háttérvilágítás is. Egyértelműen Logic board/Interface board hiba. A 3,3 V-os és 1,2 V-os stabilizátorok működnek. A képen látható elkókat kicseréltem low ESR tipusra. A kondenzátorokon lévő feszültségek rendben vannak kivéve a C404-et, itt valamiért 0V mérhető. Szintén 0V van az I308 Fet (J112xF? SOT223 package) mindhárom lábán, lásd a csatolt képeket (Logic card mosfet.jpg, Interface board.jpg).
Mi lehet a baj? Bármilyen ötletnek örülnék.
Sziasztok.
Egy kis segítségre volna szükségem. Javítok egy ilyen monitorom hibajelenség a képen látható..Tök fehér a kép. Először azt hittem, hogy a scaler és lcd közötti kábel, de amikor kibontottam a tápon találtam 2 hibás kondit (pont a scaler-táp részen). Kicseréltem mindet,de a helyzet nem lett jobb. Ezután kicseréltem egy MOSFET-et is,de késöbb kiderült újabb méréssel, hogy amit kivettem nem is volt rossz...Hol keressem még a hibát? Képeken pirossal jelöltem amit cseréltem. Nem a legjobb kép, de nem tudok jobbat :S
Sorry...
Bármilyen ötletet szívesen veszek.
Hello!
Lenne egy DELL 1907FPF lcd monitorom, rosszan kaptam.
Az LCD Panel tökéletes. Scaler jó, Táp jó.
Ami nem az Inverter.
Vagyis hiányoznak az inverter tekercsek, és az a baj, hogy nem is tudom, milyenek mennek bele.
Hozzátenném, hogy az inverter egyben van a táppal, és teljesen megegyezik a DELL 1707 FPF-ével.
Letöltöttem a service manualt de ott a pontos típusát nem jelölik.
Az lenne a kérdésem, hogy vajon milyen tekercsek mennek bele?
Ha valakinek van ilyen monitorja hánykolódik, akkor megvenném tőle ezt a panelt, ha rossz az sem baj, hátha kettőből összerakok egyet. Vagy ha van ilyen tekercse.
A linken a panel látszik:
http://www.lcdrepair.us/1707FPf_inverter-power.html
Köszi a segítséget!
Hi
I downloaded dell_2007wfpb_dvi.bin. How can I read/play this file?
Please advise
Flemming_k
I just realized that it's an EPROM file.
I was looking for the schematic and service manual