Service manuals, schematics, eproms for electrical technicians

KENWOOD KX-7010A CASETTE DECK SCH

AUDIO - SERVICE MANUAL
Type: (PNG)
Size
688.8 KB
Page
---
Category
AUDIO
SERVICE MANUAL
If you get stuck in repairing a defective appliance download this repair information for help. See below.
Good luck to the repair!

Please do not offer the downloaded file for sell only use it for personal usage!

Looking for similar kenwood manual?
Document preview [1st page]
No preview item


No preview item for this file.

Possible causes:
  • No preview picture generated yet.
  • It is not a pdf file.
Advertisements
Download free of charge (10 files / day):
Download is being processed. Please wait...
Download processing...
  • Also known:
    KENWOOD KX-7010A CASETTE DECK KX7010A KX 7010 7010A
  • If you have any question about repairing write your question to the Message board. For this no need registration.
  • If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site.
    Have a nice Day!
  • See related repair forum topics below. May be help you to repair.
Warning!
If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!

Note! To open downloaded files you need acrobat reader or similar pdf reader program. In addition, some files are archived,
so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
Translate this page:
Relevant AUDIO forum topics:
Request for Firmware or Help – Kenwood M-9000 SS stuck on "Waiting for PC Wizard"

Hello,

I recently purchased a used Kenwood M-9000 SS micro Hi-Fi system, but unfortunately, the unit is not functioning correctly. When I power it on, the display is stuck on the message "Waiting for PC Wizard", and the device becomes completely unresponsive – it does not react to any buttons or remote control inputs.

From my research, it seems that this issue may be caused by a missing or corrupted firmware, particularly related to the Sunplus SPHE8202 chipset used inside the device.

I have been trying to locate the correct firmware file (possibly DVDROM.BIN) that matches the hardware (the board ID may be BD305890BB9B50), but so far, I have had no luck finding a working download source.

Could someone please help me with:

  • The correct firmware file for this model

  • Instructions or guidance on how to recover the system using a USB flash drive

  • Any experience with solving this "Waiting for PC Wizard" message on similar Sunplus-based systems

Any help or direction would be greatly appreciated!

Thank you in advance.

Best regards,
Dejan Todorović

KENWOOD KRC-194YG autórádió nem kapcsol be
Sziasztok Mesterek! Adott a címben szereplő autórádió (rajz a tanyán). Amikor bedugom a táp(stb.) csatlakozót, 2 másodpercre felvillannak az előlap fényei és megjelenik az "ALL OFF" felirat, majd teljes sötétség és néma csend. Innentől csak a reset gombra reagál. Ha ezt megnyomom, ismét felvillannak a fények, ua. a kiírás, aztán megint csend. A BackUp +5V megvan, de állandó jelleggel jelen van a PowerOn +5V, és a +8V is. Az én értelmezésemben utóbbi kettőnek csak bekapcsolt állapotban kellene megjönnie. Vagy rosszul gondolom? Mellesleg a BackUp +5V-ot kapcsoló tranyó olyan forró, hogy az ujjam 1mp-nél tovább nem bírja. (De a fesz megvan és stabil.) Próbáltam másik előlappal is, de azzal is ua. Végső esetben szerzek mégegy ilyen rádiót és összehasonlító méréseket végzek. De ez valszeg csak holnap lesz. Addig is minden ötletet szívesen vennék! Köszönettel: Gyula
Kenwood KR-A3080 rádiós erősítő védelme kiold
Sziasztok!
A címbeli erősítő bekapcsoláskor 3 másodpercig működik majd lekapcsolja a védelem a power relét. DC nincs a kimeneten, mitől kapcsolhat ki a relé? Átforrasztottam, mert voltak rossz forrasztások, de még rosszabb lett mint előtte volt, mert előtte 1-2 percig is működött míg kikapcsolt a relé. Végfokok jók, japán ELNA kondik vannak benne jónak tűnnek. Rajza fenn van a tanyán.
Köszi.
Kenwood A-7 X Rajz
Üdvözlet minden fórumozónak. A témában említett készülék rajzára lenne szükségem, mert a tulaj belebarmolt és egy pár ellanállat szénné égett a kísérletezése közben amit nem tudok beazonosítani. Ha valakinek lenne esetleg, kérem rakja fel az oldalra vagy írja meg nekem hogy honnan tudnám leszedni. Segítségeteket előre is köszönöm. Irkax.
Similar manuals:
If you want to join us and get repairing help please sign in or sign up by completing a simple electrical test
or write your question to the Message board without registration.
You can write in English language into the forum (not only in Hungarian)!

E-Waste Reduce