Service manuals, schematics, eproms for electrical technicians

MURPHY TB 191.

AUDIO - SERVICE MANUAL
Type: (DJVU)
Size
49.2 KB
Page
1
Category
AUDIO
SERVICE MANUAL
If you get stuck in repairing a defective appliance download this repair information for help. See below.
Good luck to the repair!

Please do not offer the downloaded file for sell only use it for personal usage!

Looking for similar murphy manual?
Document preview [1st page]
No preview item


No preview item for this file.

Possible causes:
  • No preview picture generated yet.
  • It is not a pdf file.
Advertisements
Download free of charge (10 files / day):
Download is being processed. Please wait...
Download processing...
  • Also known:
    MURPHY TB 191. 191
  • If you have any question about repairing write your question to the Message board. For this no need registration.
  • If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site.
    Have a nice Day!
  • See related repair forum topics below. May be help you to repair.
Warning!
If you are not familiar with electronics, do not attempt to repair!
You could suffer a fatal electrical shock! Instead, contact your nearest service center!

Note! To open downloaded files you need acrobat reader or similar pdf reader program. In addition, some files are archived,
so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
Translate this page:
Relevant AUDIO forum topics:
Trouble with TL072 op amp in audio preamp build

Hi everyone,
I'm experimenting with the TL072 in a small audio preamp project, but I’m running into some confusion. The circuit powers up, but I’m hearing noticeable noise and distortion when I increase the gain. I’ve double-checked the wiring and power supply (±12V), and the pinout seems correct.

Could this be related to the package type (SOIC vs DIP) or do I just need better decoupling caps? Also curious if there are drop-in equivalents that might perform a little cleaner.

Any advice would be really appreciated!

AIWA AD-F260 fejhallgató illesztés
Üdvözletem !

Egy AIWA AD-F260 deck fejhallgató kimenetéhez szeretnék illesztő áramkört készíteni .
A neten találtam egy használatit mely szerint 32 ohm - impedanciájú fejhallgató kimenete van .
Az én fülesem 64 ohm -os s rettenetesen hangosan szól.
Gondolom amikor ez a készülék készült még nem voltak ilyen érzékeny fejhallgatók s ezért van túlvezérelve.
Elegendő e egy -egy 33 ohm -os ellenállást sorba kötni a jobb -bal csatorna jelvezetékéhez vagy valamilyen feszültség osztóra van szükség.
Kérdésem hogy tud e valaki olyan illesztő kapcsolást amely megoldaná ezt a problémát ?
Előre is köszönöm ! 
Üdv: István
Technics SE-C01 erősítő táp probléma
Sziasztok! Évek óta itt kallódik már nálunk ez az erősítő, az a probléma, hogy a készülék (korához képest formabontó módon) kapcsoló üzemű tápegységet tartalmaz, amivel az a probléma, hogy 120V-os rendszerre méretezték. Volna valakinek ötlete arra hogyan lehetne ezt az erősítőt a hazai villamos hálózathoz illeszteni anélkül, hogy egy bunkó autotranszformátort kötnénk vele sorba? gondolat ébresztőnek Mint látható a linken a készülékben semmiképpen sem fér el ilyesmi, ezért volna jó, ha valami okosat kitalálnátok :)
SUB láda építése kis méretben.
Sziasztok!

Igaz nem HiFi téma.....
Hanem kimondottan hangfal.
De hátha maradhat.wink

Nincs valakinek jól bevált SUB láda terve?
kimondottan kisebb méretben?
Egyértelmű, hogy rétegelt nyírfa lenne a láda alapanyaga! smiley

Úgy kb: 65*45*45cm-es mértben?

Van nekem is jó pár tervem, de az mind jóval nagyobb PA széria! 
0,9-2m³-es.
Ezek meg brutál nagyok nekem!

Nekem kb egy 30m2-es helyiségbe kellene.
Érzékenység területén kb 95-100dB.
Ahogy sokan mondják..... Szépen BUFFOGÓ! heart

Szóval ha házibuli van....
Akkor is "masszírozzon"!
Én ezt szeretem! devil

Akár egy eredeti Reflex R400-as méllyel....
Vagy egy Beyma a régi Reflex hangfalas szériákból.
Vagy Master Audio-s. 

Amúgy aktív kivitelbe készíteném el.
Mert egy 2.1-es rendszer van tervben.....
A TOP láda terv az már megvan.

Előre is köszönöm.

 
Similar manuals:
If you want to join us and get repairing help please sign in or sign up by completing a simple electrical test
or write your question to the Message board without registration.
You can write in English language into the forum (not only in Hungarian)!

E-Waste Reduce