Sziasztok!
Ez a gép a sajátom. Már párszor átnyálaztam a használatiját, de nem jöttem rá, hogy az elkészített képeken hogyan lehet megjeleníttetni a készítés időpontját. A gépben történő kép nézegetéseknél még megjelenik a dátum-idő, de ha átmentem PC-re, már nincs sehol. Valószínűsítem, hogy ez a gép nem rendelkezik ilyen funkcióval, de hátha valaki okosabb nálam! Ha tudtok valami okosságot, kérlek, segítsetek!
Köszi! Laci
Üdv, mindenkinek.
Az lenne a kérdésem,hogy meg lehet-e javitani egyszerüen, vagy teljesen szét kell szedni hozzá az optikát?
Ha igen akkor hagyom igy ahogy van. Leesett és azóta ilyen. A kijelzö is berepedt de azt már kicseréltem.
Igy is oké, csak sokkal töbször kell tisztitani az optikáját, hiába van tokban.Nem véletlenül találták ki azokat a lemezkéket.
üdv.
https://ibb.co/rZFPjDQ
initialy the GH5 viewfinder (LVF) would not display anything when I looked through it, indicating a possible issue with the power supply or the internal connection to the viewfinder circuit. So i Opened the camera and inspected the flexible ribbon cable connected to the viewfinder PCB.
-
Identified a potential problem with the FPC connector, which appeared loose and damaged at the pin connection points.But i resolder it.
-
And i Tested the continuity of key components the power board,even the flex cable by cotinuity.
-
After that, testing, the device did not power on at all, even after check the ribbon cable and ensuring the battery was functional.i have 3 diffrents.
-
Currently i'm thinking on check if the power board (DC-in connector) has a short circuit or other internal faults that might have caused the system failure
Does someone can confirm which part i have to test and which component maybe ?
Can anyone confirm which specific components I should test further?
Thank you!
Sziasztok!
Ezt a gépet szüleim vették 2005-ben, azóta folyamatosan ment :)
A probléma szerintem folyamatosan egyre rosszabb lett, miszerint ma már ha új elemet teszek bele, akkor is azt írja lemerült.
Ez a szokásos zárlat lehet, több fényképező is csinálta, visszaemlékezve fórumtopikokra.
Nos én meg tudom itthon csinálni? Átvezető smd vagy hasonló lehet a rossz benne?
Köszi!
Üdv:
Pityesz