Sziasztok!
Ez a készülék bekapcsoláskor elég gyakran kép nélkül indul, csak lila fény látható, hang van.A kijelző aljának megütésére megjőn a kép és marad is.Menet közbeni mozgatásra van amikor kimerevedik a kép.LVDS kábel mozgatására nem reagál.
Ennek a hibának a megoldásában kérném a segítségeteket.
Üdv.: Laci
Üdv!
Érdeklődnék van-e valakinek elképzelése miért olyan gyanúsan olcsó az ára sok áruházban a
Panasonic tx-p42u10e típusjelű plazmája??
Az érdekessége, hogy full HD (1920*1080) kijelző mellé még DVB-T tunert is tettek, ami alkalmas
a hazai földfelszíni digitális műsorok vételére is.
Mindenhol 179.990.- HUF az akciós ára.
Sajnos a Panasonic mintaboltban sem tudtam kideríteni miért ilyen olcsó....
Érdekelne érdemes-e megvenni, nem valami széria hiba miatt lett leértékelve??
Zoltán
This elderly monster arrived with the error “ 4 blinks “ which the manual suggests is a power board fault
There are TWO power boards and a standby power board inside
On removing rear cover there were two swollen 220uf caps on the standby board, sadly replacing them the 4 blinks remained
Swapping the two power boards over[ as they look identical , gives a “ 2 Blink “ error , the limited info in the manual suggesting that the fault is on the lower board [ main 2 ]
Both boards have a PFC voltage of around 380 volts at switch on before the relays click out
I have done cold checks on both boards and there are no obvious differences
As the manual has only a block diagram of the power supply it’s difficult to be sure of values / voltages
Has anybody seen or worked one of these or similar beasts and managed to diagnose the problem
Thanks for looking
Regards Ken
Panasonic TX-40DXF687 -más modell is jó,csak az alaplap szám egyezzen.
Alaplap:TNPH1160 A1
Ha van valakinek,emmc tartalma vagy ilyen alaplapja hozzá azt megköszönném!