Hiba Jelenség:Bekapcs után azonnal, vagy 3-4 perc után kikapcsol.A stby is eltünik.Majd elkezd sürün villogni a stby,2-3 mp után visszakapcsol hangyás kijelzővel.
Megoldás:A tápban a CM812cs kontakthibás.Forrasztani!
Szia!
Már bocsánat, de 14 év után csak ilyen címre telik? Őszinte részvétem!
Kalex
Jónapot mindenkinek!
Hozták ezt az lcd-t: DLP-32B3T Ch:Z1J190R-8
Készenlétből nem hajlandó elmozdúlni(se táv se taszról).
A feszültségek az alábbiak:
rajz szerint ténylegesen mérhető
24v 24v
12v 15v
3.3v 3.46v
2.5v 2.5v
1.8v 1.8v
5.0v 5.09v
8.0v 8.22v
Ha leválsztom az invertert és a kijelzőt, akkor is ezek mérhetők.
Tehát a táp úgy tűni,jó. A leosztásokban már nem vagyok biztos.
Eepromot cseréltem.
Ebben 24c32an volt,tettem bele 24c32wmn6 jelűt. Ennek 2.5v-tól kell működni.
Sajnos nem hatotta meg. Ugyanúgy nem kapcsol be
Segitséget kérnék. Mit nézzek még? Mi okozhatja,hogy nem indúl?
Úgy tudon hálózat bekapcsoláskor indúlni kellene neki.
Azt nem tudom,hogy ha készenléten van akkor kellene-e villogni a készenléti lednek a táv. nyomására? Ez nem villog.
Köszönöm:Géza
Sziasztok!
A cimbeli plazma tv-nél kb. 4-5 órai működés után elmegy a kép a hang marad. Kikapcsolás után visszakapcsolva sincs kép csak hang. Ha megvárom míg kihűl, akkor újra jó a kép is 4-5 óráig. Mi lehet a hiba? Köszi a segítséget!
Sziasztok a készenlét ledje 5-öt villog majd ismétli távra gombokra nem reagál a tápján az 5,3v megvan jó lenne a tápot elinditani hogy többet lehessen mérni a pfc körön 350v mérhető a 450v kondenzátoron gondolom akkor indul mikor a mainról megkapja az inditást.Az öt villogásról szinte semmit sem találtam