T. Tanyalakók!
A segítségeteket kérem a címben szereplő probléma megoldására.Sajnos képet nem tudok produkálni, mert mire reagálnék, már minden ok. Előzménye az volt, hogy nem indult. A tápban volt egy púpos kondi, kicseréltem nagyobb feszüre, minden ment, járatás közben véletlenül vettem észre ezt a problémát.Rajzot a tápról sajnos nem találtam.Ez a táp van benne PSLF201502A.
Már ez is sokat segítene, ha lenne valakinek.
Minden jó tanácsot elfogadok.
Sziasztok!
Keresném a köv T-cont:RUNTK 5351TP 0055FV
Jelenség hang van, kép nics,háttérvilágítás van, világít rendesen de kép továbbra sincs. A T-con megkapja a 12voltot.
Üdv: Attila
Hali!
Van nálam egy ilyen TV javítás alatt az a baja hogy Stand-by üzemben sípol a tápja ha be van kapcsolva a TV akkor semmi gond vele.
Elkókat cseréltem benne de továbbra is ez a gond.
Mi lehet a hiba mit nézzek meg benne még?
SIP400B táp van benne.
Köszi!
I have this TV equipped with the source BN44-00134A.Tv does not start, it is heard how the relay is continuously coupling and disconnecting. The stable voltage drop is STB = 6.5V, P-ON / OFF varies between 0.2-2.5V in normal operation = 2.6V) PFC between 360-385V (when going is 382V). All electrolytes, secondary-primary, have been changed, except the 220uF / 450V which is ok. In this state, if measure the voltage on the pins 1-2 to optocoupler PCS802, the relay stay connect and tv work normally . I have replaced the PCS802,801, the ICS 802 (KIA431), the QP803, the QS801, the QS802 checked. If I stop it(unplugged) and I restart the tv in a few minutes, it works normally, if I leave it a little longer, the defect returns. Any suggestion is welcome, I do not think it would be the problem with the mainboard. Thank you!
I attach the power supply+ inverter schematic model BN44-00134A