Translate this page:

Sziasztok! A fenti kamerához kérnék segítséget és rajzot. Nem kapcsol be. Az áramfelvétele 0,7mA. Hiába kapcsolom PLAY vagy CAMERA módba nem történik semmi és az áramfelvétele sem változik. Nem látok benne semmi gyanúsat. Megvizsgáltam azt a panelt, amin az akkucsati van. Tele van DC/DC átalakítókkal. A félvezetők, tekercsek, bisztik jók. A továbblépéshez kellene a rajz, mert azt sem tudom, hogy a soklábú flex csatin melyik láb vezet a kapcsolóhoz. Köszönöm.

üdv: egyik ismerősöm panaszolja, hogy címbeli kamerája fél órai működés után meleg. Megmértem, a bal oldala 35 C-fok körül van, az alján az állványcsavarnál 42 fokot mértem egy órai üzem után. Kérdem, ez elfogadható, vagy hibára utal? A kamera egyébként normálisan működik. Bálint

Hello everybody,
Sony CCD TRV-238E camcorder has two issues, first, a wire in the harness( PD-124) is almost cut, which causes bad contact in the LCD panel, I've tried to used a sort of glue to fix it but without success, soldering the two parts is almost impossible ( see picture), the area is too tight.
Second,  when the connexion for standard flexible are cut it is possible to scratch the two parts and connect them with extension wire and welding, but in the case of the CONTROL KEY BLOCK's flexible which is used to connect the CONTROL KEY BLOCK to the mainboard, connexions are not made of copper!  (carbon maybe, trying to polish  will destroy them!), actually, they are worn out (see picture).
Because these spare parts are no longer available in my country,  please I need your advice to fix harness and CONTROL KEY BLOCK's flexible.

 

Hi everyone,

Could somebody tell me how I can get (or buy) the Sony AdjustStation with the adjustment manual for my old Sony A55V camera? Recently, the IBIS died in this camera, and after some time the shutter died too. This rendered the camera completely unusable. Since the camera is quite old, no repair shop near me was willing to fix it at a reasonable price. So I bought the shutter unit and IBIS on AliExpress and successfully swapped them. The problem now is that the shutter is clearly misaligned. The service manual says that after replacing the shutter and IBIS, they must be calibrated to work properly. According to the manual, AdjustStation software is required for that. The camera is very important to me as it holds many memories, so I’m determined to get it working again.