Sziasztok! Ha tudtok egy rajzot erről a készülékről, nagyon megköszönném!
Want to share:
Have downloaded the schematics from this forum to help repair the amplifier of a friend.
Turned out that Sony decided to route the earth through the chassis, even the earth between the various supplies.
When one takes the main board out of the chassis and switches the amp on, there are up to 20 volts difference between the eart (and hence reference) of the pre-amps and the main amps.
Luckily the amp goes into protection but from a design point of view it is not nice to rely on screws and aluminum face plates to conduct up to 0.2 amps of current from one supply to another.
What I did is solder wires to every eart point and connected them on the main board to make it stand alone and not rely on conducting current through the chassis anymore.
Bad design, simple repair but took some digging in the schematics to find out what exactly was going on!
Hello,
Sony TA-F317R erősítőben a végfok tranzisztorok és a meghajtó IC megadták magukat. IC szállítás alatt, viszont tranzisztorokat elfogadható áron nem tudtam beszerezni, így a helyettesítés maradt.
Eredetileg 2SC3853 (NPN) és 2SA1489 (PNP) komplementer párok vannak benne. Itthon a 2SC2581 és 2SA1106 párost találtam, ami nagyobb áramot bír és elég hasonlóak a paramétereik és szintén komplementer párok.
A neten BD245 és 246 helyettesítést ajánlanak, de ezek paraméterei eléggé eltérnek az eredetitől.
Kérdésem, a fenti 2SC2581 és 2SA1106 páros megfelelne-e v. simán használjak BD 245-246-ot, nem okozna gondot és nem kell a munkaponton állítani? Szükséges-e a másik (jó) végfokban is cserélni a tranzisztorokat (hogy szimmetrikus maradjon)?
Köszönöm.
Üdv
DR
Sziasztok!
Forrasztásokat átnéztem, végfoktranzisztorok nem zárlatosak, a 0.22 Ohmos ellenállásokon 0V-ot mértem.
Van ennek a típusnak valami jellemző hibája, amitől aktiválódik a védelem?
Tápot még nem mértem, mert szétborítva nem tudom bekapcsolni (vagy mégjobban szét kellene borítanom.)
Üdv: Jácint