Sziasztok,
nem nagyon szoktam ilyeneket javítani, elég kevés tapasztalatom van ezekkel.
A készenléti LED világít, de onnan nem indul tovább sem távirányítóval, sem a kezelőgombokkal. Távirányító jó. Viszont az infravevőn 3,3 Voltot mérek. Én a rajzon úgy látom, hogy itt 5 Voltnak kellene lennie. A tápegységről jön le egy 6,1V, a rajz szerint itt 5,6-nak kéne lennie. Azt még nem sikerült megfejtenem hogy ennek az állítólagos 5 Voltnak pontosan honnan is kéne jönni. Esetleg van valami jellemző típushibára vonatkozó tapasztalatotok? Nekem ez sokkal áttekinthetetlenebb mint egy TV...
Köszi.
Tamás
Want to share:
Have downloaded the schematics from this forum to help repair the amplifier of a friend.
Turned out that Sony decided to route the earth through the chassis, even the earth between the various supplies.
When one takes the main board out of the chassis and switches the amp on, there are up to 20 volts difference between the eart (and hence reference) of the pre-amps and the main amps.
Luckily the amp goes into protection but from a design point of view it is not nice to rely on screws and aluminum face plates to conduct up to 0.2 amps of current from one supply to another.
What I did is solder wires to every eart point and connected them on the main board to make it stand alone and not rely on conducting current through the chassis anymore.
Bad design, simple repair but took some digging in the schematics to find out what exactly was going on!
SONY STR DE 698 tipusú erősitőn nem lehet BEMENETET választani. Nem reagál egyik kiválasztógombra sem. Próbáltam RESET-elni az interneten megadott módon , de sajnos ugyanaz a helyzet, visszaáll a tiltott állapotba. Vajon elektromechanikai hibája lehet. esetleg valami védelem kapcsolja mindig vissza. Van valakinek valami ötlete ?
I need a diagram and description of the SONY SRP-P2025 amplifier. It does not turn on, only the LED output indicator does not work and lights up, the high-current circuit does not work.
Пишите на английском или венгерском языке!
модератор