Translate this page:

Hi everyone

Could somebody tell me if I can replace a switching diode to another one, the one installed in the onkyo is a 1SS252 and is 10 times more expensive that a 1SS355.

Usually I order the same but they are pricey (around 10.00 usd for a 100) and not commonly used, not many sellers.
For the 1ss355 every seller on line has it in stock and it's around 1 to 2 usd for a 100.
Ans they are available locally, not in china waiting 5 weeks for the part.
Thank you.


1SS352
Characteristic Symbol Rating Unit
Maximum (peak) reverse voltage VRM 85 V
Reverse voltage VR 80 V
Maximum (peak) forward current IFM 200 mA
Average forward current IO 100 mA
Surge current (10ms) IFSM 1 A
Power dissipation P 200 (*) mW
Junction temperature Tj 125 °C
Storage temperature Tstg −55~125 °C

1SS355

Characteristic Symbol Rating Unit
Maximum (peak) reverse voltage VRM 90 V
Reverse voltage VR 80 V
Maximum (peak) forward current IFM 225 mA
Average forward current IO 100 mA
Surge current (1s) IFSM 500 mA
Junction temperature Tj 150 °C
Storage temperature Tstg −55~150 °C
 

Hello, I am in the process of repairing the Mackie ProFX12 V2 mixer for a client, and am running into the unavailability of schematics. Does anyone have a copy they could share? I have already reached out to Mackie directly but am still waiting for a reply.

Additionally, I am having trouble identifying the failure mode for the two channels that have failed: one produces loud static (indicating bad op-amp or feedback resistor perhaps?) and the other has the right channel producing a 60hz hum, the other is functional. (see board photos, with the two failed channels being marked with "F". The browned area is residual flux from having replaced two opamps, and having reflowed other components around them)


Any help on either of these fronts would be invaluable. I have mainly worked in laptop and computer repair, and am just getting started with my first scope and first set of board level repairs. 

On 170mm automatic play is ok (after use Start bottom),on 330mm is no arm move.What"s solution?

Sziasztok! A mai napon kaptam ezt a közép kategóriás aktív hangfalrendszert javításra. Pár perc alatt kiderült, hogy végfok problémáról van szó. A beazonosításnál viszont az a problémám,hogy nem találok sehol ilyen alkatrészt! jelzése: D2030A , tokozás: TO-220/5, bár első felindulásra TDA2030-ra gondoltam, mert azt legalább ismerem, és ugyanez a tokozás! Természetesen erről rajzot nem találtam sehol, és így nem merem berakni a TDA-t! Esetleg, ha valaki jártasabb, vagy javított ilyen rendszert, nagyon megköszönném a segítségét!!!