hi.
hozzám került tartós vizsgálatra a fenti plazma-a biztosító nyártól mostanáig vajúdott rajta.(villámos volt)
átnéztem-nincs kép,ymain halkan vísít,
kiszedtem az y maint és találtam rajta "értékváltozott" alkatrészeket,ja az stk 795-844 is gyanús,mert minden ami rossz az stk hibrid körében van.
találtam rajzot a tanyán,de hiányos-pont ez a rész hiányzik....
lenne -e valakinek rajza,vagy tapasztalata hogy érdemes-é foglalkozni a javítással-esetleg keressek panelt??
a panel száma: LGE pdp070306 50x4A
eax34042601
Üdv: egon
loviegon@t-online.hu
30-9 986 575
Hello, does anybody has a hint for me and/or schematic for the Hisense RSAG7.820.12363 mainboard?
Issue TV : no startup, from standby, red led TV flashes continuously, remote checked, no component, connector, solder joint seems visual defect, no hot spot with IR camera, guess power supply or safty circuit defect.
br markus
Jó reggelt Urak!
SzBálint javaslatára, a kérdésem áttem a HISENSE témából erre fórumra, hátha itt tudtok segíteni.
Van egy HISENSE 43A7KQ TV-m.
Három napja frissítette magát. Azóta két gomb nem működik a távirányítón, és a menüje még rosszabb lett, mint volt (bizonyos funkciókat alig lehet elérni).
Eszembe nem jutott, hogy az amúgy is híresen sz@r szoftvert tovább lehet rontani egy frissítéssel. De, lehet.
Hogy lehetne visszavarázsolni a régi szoftverét? A neten csak upgrade-vel foglalkozó oldalakat találok, de a visszaállítás lehetőségét nem.
Előre is köszönöm a segítséget.
Dear all,
this TV, Hisense H60N5705 installed in a conference room, turns off automatically a few minutes after being switched on.
The problem started to occur suddenly, during a video conference. It was switched on with the remote control, continued to work for a while and then switched off again.
The room technician changed the power cable (?), the HDMI cable (??) but the problem of course remained.
I asked if it changes anything by connecting the TV to another source but, even if it is left on the OSD menu, it stays on for a few minutes and then switches off.
So they took the TV (a 60’ which is not easy to handle) to the lab and asked me to check it.
I still have to open it up, but I don't have the schematic diagrams and should proceed by trial and error, although I imagine a problem with the power supply stage.
How do you suggest I proceed, since I don't do TV but RF ?
Thank you for any help,
Best
Maximus