Download free of charge (10 files / day): Download processing...
Also known:
NATIONAL RF-885L RF885L 1965 RF 885
If you have any question about repairing write your question to the Message board. For this no need registration.
If the site has helped you and you also want to help others, please Upload a manual, circuit diagram or eeprom that is not yet available on the site. Have a nice Day!
Warning! If you are not familiar with electronics, do not attempt to repair! You could suffer a fatal electrical shock! Instead, contact your nearest service center!
Note! To open downloaded files you need acrobat reader or similar pdf reader program. In addition,
some files are archived, so you need WinZip or WinRar to open that files. Also some files are djvu so you need djvu viewer to open them.
These free programs can be found on this page: needed progs
If you use opera you have to disable opera turbo function to download file!
If you cannot download this file, try it with CHROME or FIREFOX browser.
A barátom cd játékosa került hozzám nemrég, a sztori úgy indult hogy egyszer csak elhallgatott és se kép se hang, ennek 5 éve most elhozta hogy kukkolja már bele mi lehet a nyűgje, első bizti csere mivel ki volt égve, aztán ráköt a hifire és csak ilyen sercegéses zúgás tör elő belőle, cd bele olvas mindent, de a zene mellé párosul ez a búgó zúgó hang mintha test hiánya lenne de ezt átnéztem és minden rendben, ötleteket szivesen fogadok.
Egy kis videó arról hogy mi a hiba:
I have a Yamaha CDX-590 CD player and it skips on some CDs - original CDs, these CDs play without problems on my other CD players.
I have changed the laser unit (KSS-210A) but this didn't solve the problem.
When I turn the player upside down, it plays the problematic CDs without a problem.
That's why I think the laser needs adjustment.
I have only a service manual for the CDX-493/593 but they should be very similar to the CDX-590.
It seems that the adjustments are done via "test mode" of the CDX-590, unfortunately there is not much information, how to exactly, in the service manual.
Here is a picture of the PCB.
http://www.volny.cz/hwtest/PCB.JPG
Here are the "test mode" sections of the service manual.
http://www.volny.cz/hwtest/TM1.GIF
http://www.volny.cz/hwtest/TM2.GIF
In "test mode" I have tried Auto adjustment mode 1, 2, 3, but I don't know if it should work fully automatic without any intervention or when the mode is fineshed and I can proceed to the next one.
So I activated mode 1, waited a while, activated mode 2, waited a while, activated mode 3, then exited test mode.
It didn't help.
Mode 1 - only a short blink of two horizontal dashes on the display and thats it
Mode 2 - started "play" without sound from a strange time 99:00 (the test CD is not so long), after a while it skips to another time, "plays" a while, then skips back and "plays" and so on, I left it about an hour and it was still going on
Mode 3 - seems to be very short as mode 1
I think I'm missing something ...
Maybe someone did this or even serviced Yamahas in an official service and can provide information how to adjust the laser?
Or maybe the problem is not the laser?
Sziasztok!
A következő problémával fordulnék hozzátok. Az egyik barátom Honda Jazz tipusú autójában a gyári fejegységgel adódott problémám. A tipusa: MF9HN08L/MF622RV. Ez egy CD-s rádió. A hiba a következő: minden egyes funkció működik rajta csak a rádió hallott. Nem hangol, nem csinál semmit. Cd és egyébb funkciók mennek rajta. Amit eddig csináltam az a tucatnyi kh megszüntetése. Rajzot nem találtam róla. Itt megakadtam. Ha valaki tud ebben segíteni , hogy merre induljak az ötleteket várom.
A segítséget előre is köszönöm: Gábor
Minden Segítséget köszönök! Az Egyik 0-ohm os Átrkötés volt szakadt. a tunerben.
Lassan 15 éve pihen a műhelyben ez az erősítő, egyetlen hibája az egyik végfok meghajtó driver IC (CX171) rossz. Sajnos eddig semmilyen forrásból nem tudtam szerezni hozzá, kifutott alkatrész mindenhol. Átalakítani nem akarom...
Most felcsillant a remény, Ohio-ból egy alkatrész forgalmazónak van 2db amit 100 € + posta ellenében megkapnék. (125€/db-ról indultunk). Nekem csak egy darabra van szükségem, ha valakinek kell ilyen IC és bevállalja velem a kockázatot, akkor az egyiket átadom. Tudom így se olcsó, de ez az erősítő megérdemli, hogy eredeti állapotban szóljon tovább - mindkét oldala.
If you want to join us and get repairing help please sign in or sign up by completing a simple electrical test or write your question to the Message board without registration. You can write in English language into the forum (not only in Hungarian)!