This elderly monster arrived with the error “ 4 blinks “ which the manual suggests is a power board fault
There are TWO power boards and a standby power board inside
On removing rear cover there were two swollen 220uf caps on the standby board, sadly replacing them the 4 blinks remained
Swapping the two power boards over[ as they look identical , gives a “ 2 Blink “ error , the limited info in the manual suggesting that the fault is on the lower board [ main 2 ]
Both boards have a PFC voltage of around 380 volts at switch on before the relays click out
I have done cold checks on both boards and there are no obvious differences
As the manual has only a block diagram of the power supply it’s difficult to be sure of values / voltages
Has anybody seen or worked one of these or similar beasts and managed to diagnose the problem
Thanks for looking
Regards Ken
Sziasztok!
Jó pár órát meg egy vödör forrasztóónt elnyaltam rá, de úgy néz ki jó lett.
Hiba, kikapcsolt 15 perc után (megszólalt a védelem), főkapccsal kikapcs, majd újra be és megint jó volt, de egyre kevesebb ideig.
Nos,a sorkimenőn kívül ma még az eltérítő stekkert is átforrasztottam, plusz egy kazal SMD ellenállást.
Egyik az R639 volt a leggyanúsabb, mérve össze vissza szinte mindig mást mértem rajta. valószínű mikroszkóp alatt ha megnéztem volna, szépen kirohadt forrasztásra bukkantam volna.
Egyenlőre megy egy jó ideje, kopp kopp.
Tanulság, ne kíméljük eme alaplapnál az SMD-ket :)
Külön köszönöm kedves Panasonic-os barátomnak a segítségét :)
Üdv:
Pityesz
Hello,
I have a Panasonic TX-68PS20A 68cm (29") Television with a GP3 chassis. (Australian PAL model)
The documentation I have found online says that the gp3 chassis supports VHF PAL-B/G and NTSC-M. However my tv doesnt support M audio. It just tunes the video and gives white noise through the audio since it's looking for B audio even though it's displaying ntsc video just fine.
I have found no options for this in any of the service menus I've accessed. Am I missing something?
I don't mind if I have to reflash something to make this work.
Here is the pdf which I read the specs from, it's not for this model but a similar one with a gp3 chassis. http://elektrotanya.com/cgi-bin/download2.cgi?uid=37145&cid=1417425157&fid=117149&file=panasonic_tx-29psxx_gp-3.pdf&x=26&y=30
Sziasztok!
Kis segítség kellene a fenti készülékhez 21 "-os .Lehet volt már itt is róla szó azért leírom mi van. A tulaj elmondása szerint az utóbbi hónapokban a tv bekapcsolás után nem mindig indult.Ezen ő ütögetéssel segített és indult végül egyszer menet közben állt meg és azóta csak kis led villog.A készüléket kibontva komoly kh-t nem találtam és zárlatos dióda illetve semmi sérülés nyom .A nagy táp is beindul de le is áll. A sorvégtranyón is mérek feszültséget egy pillanatra és ennyi.Van valakinek ötlete? Előre is köszi!