Sziasztok!
Az a gond vele, hogy nem csinál semmit. Ha megnyomom a távon valamelyik gombot, akkor a stby led villog. Másik mainnal megy a tv. Van valakinek megoldása rá? Köszönöm!!
Hi everybody,
I have Philips 40PFL7007K/12 on repair. TV does not start up. I have checked the PSU and it seams to be OK. There seam to be problem on the main board.
What I have tried…
Well, there is +3V3-STANDBY coming from PSU to main board. This feeds up the main processor. This voltage has also been used to switch TV on. I have checked that switching signal from POWER ON button goes back to main board. But I did not check this whole path towards the processor as it is BGA package and it is covered by ceramic cooling plate.
And here comes what is not clear to me.
1. How to check if the main processor works? Does it work on the +3V3-STANDBY when TV is is standby mode?
2. Can I somehow check if the PSU is working? May be by activating some pin?
3. I have noticed by measuring (ohm-meter) some capacitors on the main board (in circles on the picture) that there is very low resistance on them (4.5ohms). In the scheme it is shown that these capacitors are on the 1V5 (1.5V) line. Is this OK? Basically it does not give much current as I = 1V5 / 4R5 = 333mAmps. What do you think? Certainly there are low voltage data parts (RAM. Processor …) connected and such resistivity might be correct….?....
What I have also find that this 1V5 is split into 1V5M0 and 1V5M1. See the picture. I have removed the coils and measured resistance. Then 1V5M0 shows about 15ohms and 1V5M1 shows about 6,5ohms.
The service manual is on this link:
http://elektrotanya.com/philips_ch.qfu1.1e_la.pdf/download.html
Thanks Martin
Üdvözlet Mindenkinek!
A készülék /sasszi:EM2E,képcső:68ERF/alig látható fényű képernyőn,halvány visszafutási csíkokkal került hozzám.A G2 tekergetésével sikerült előcsalni egy kék-zöld képet.A képcsőre rámérve,G1-R katód zárlatot találtam /0,5 Ohm/.A zárlatot mérve, a képes felére helyezett képcső nyakát kocogtatva,kb.5 perc alatt elment a zárlat,szép kép van, minden funkció hibátlanul működik.Bekapcsoláskor egyszer-egyszer bevillan a halvány, piros alapú raszter visszafutási csíkokkal,/valami még ott van a korábbi zárlatból?/ de utána megjön a kép rendesen.Tapasztalt kollégák véleményét kérném,milyen anyag okozhatta a zárlatot? Érdemes "meglőni" ezek után még a csövet?
A készülék milyen üzemmódjában lehet belépni a szervíz módba? /A belépési kódot ismerem /
Sziasztok!
Egy kis segítség kellene, egy Philips 20GX 8550 tévéről lenne szó.
Táp megállt és TDA4605 típusú IC van benne. Nem tud valaki kapcsolási rajzot hozzá?
Előre is köszönöm!
Szép napot mindenkinek!
Vonal