Screenshots of problem here in the post.
Picture of screen with both cables to panel from TCON connected, and the other is with one side disconnected.
I have read the cables from the TCON to the display loosen up on the end to the panel. I believe as I am working on moving the cables around, the picture is improving
and getting clearer. So I think thats the problem. Someone mentioned using tape over them to hold them to the panel better. I have not taken the metal frame off to
look at them, but there is a narrow gap where I read some people stuff cardboard in there to press down on them better.
Has anyone ever seen this issue and come up with a good way to resecure the cables?
Sziasztok!
Jó ideje nálam van, most megcsinálgatnám 7végén :)
Cső halott volt, megoldottam, de!
A kép bal szélén függőlegesen egy jó pár centis vastag fekete sáv van, ahol ugye képtartalom nincs, plusz csatornaváltáskor a fényerő pillanatra megemelkedik és lélegzik a kép.
Fényerőt ha ráadok pláne lélegzik. jó a gondolat menetem, hogy a sugáráram ahogy növekszik, nem bírja a táp a terhelést, tehát lehet ki kéne hajigálni az elkókat a tápból?
Köszi!
Üdv:
Pityesz
Üdv!
Fenti készülék bekapcsol, de a led háttér világítása nem megy. A két csík teszterrel egyenként mérve 55V-on szépen működik. A táp felől viszont csak 64V-ot kap (ennyi a max bejövő is, a FET és a source kör rendben) és mivel soba vannak kötve ez nagyon kevés. Ha a csíkokat egyenként kötöm be, működnek, nem tilt le a védelem.
Hol lehet a hiba?
Tisztelt Mesterek!
A fenti TV nem mindig kapcsol be. 11 x fölvillan a léd többszeri próbálkozásra van,hogy bekapcsol akkor normálisan megy a kikapcsolásig...Ha valakinek van ötlete ossza meg velem.
Köszönöm előre.
Üdv:Kocsis Gy