Hi
My Fender Mustang 3 (Ver2) died while I was plugging in my 2 button switch. The amp was on, the 4 button switch and foot pedal were already connected.
The DIsplay just went blank (Amp and Foot switch)
No lights come on when switching the amp on so reset by holding down the exit button is not an option. The blank display just glows.
The power amp is still fine. I tested this by feeding an MP3 player into the Aux input.
So I am assuming the Power Supply is also OK but can't be 100% sure as the only schematic I could find is for Version 1 and mine is Vers 2
I reseated the DSP board but this had no effect. It looks like I need a new DSP board.
The DIsplay just went blank (Amp and Foot switch)
No lights come on when switching the amp on so reset by holding down the exit button is not an option. The blank display just glows.
The power amp is still fine. I tested this by feeding an MP3 player into the Aux input.
So I am assuming the Power Supply is also OK but can't be 100% sure as the only schematic I could find is for Version 1 and mine is Vers 2
I reseated the DSP board but this had no effect. It looks like I need a new DSP board.
Does anyone know where I can order a DSP board from Fender?
Does anyone know of a link to a schematic for the Fender Mustang 3 VERSION 2?
Any help would be greatly appreciated.
Thanks
Alan
Comments
Hello Alan,
The schematics is here
Good luck to repair!
TJ
0