Sziasztok Kollégák!
Belefutottam a fent említett tv-be,ehhez kérnék segítséget.
A hangerő alapból 0-tól 100-ig szabályozható,elvileg.
Ő viszont bekapcsoláskor 135-as hangerőről indul,ha elkezdem levenni,akkor 100-ig szépen halkul.100-nál teljes hangerőn üvölt és halkul,ha leveszem a hangerőt.
Remélem érthetően fogalmaztam.
Köszi Tomi
Sziasztok. Ehhez keresek nand tartalmat. Hol lehet letölteni vagy van valakinek ilyen?
Hi, my SAMSUNG UE40D5000 tv doesn' t work anymore. The red led light indicating that the tv is plugged is not powered when I plug in the tv. The original power board modem is BN44-00473B. I have checked the voltage on the connector to the mother board of the tv, and it was 0 instead of 5.3V or 13V on the different pins, with the fuse still working and no obvious overheated part on the power board and no bulging capacitor seen neither.
I have then changed the power board with a used one bought on ebay, which model BN44-00473A is said to be compatible. It has then worked perfectly 2 days until yesterday. This morning I had to move a little bit the tv, what I did very gently, and got really disappointed as I plugged it and didn't see the red led light on anymore.
Since this morning, the power board seems to be broken once more ( I have moved from my original flat 1 week ago and don't have a multimeter to check once more that the fuse is ok and what are the voltage on the connector to the mother board )
I am wondering if this new power board failure is just bad luck, 2 days after receiving this other power board circuit ( that is a used unit, not brand new) or if the mother board could have damaged it. In the first case I would send the power board back to the seller, otherwise I will probably give up as I don't have time and skills to repair the tv.
My question is : do you think the mother board or another unit connected to it, can damage the power board ?
Thanks for your help and answers !
Sziasztok!
A fent említett tápegység (Samsung V4C) javítás után a Vs és az ebből előállított feszültségek hiányoznak. Az IC301 és IC401 volt elpukkanva benne + a környékükön pár dióda és ellenállás. Cseréjük után a Vs kivitelével az összes fesz. rendben megjött. Ezután az IC103 és IC203-at cseréltem, a szekunder körben egy csomó megnyult W-os ellenállást is cseréltem, a kondik nagy részét (a VS körben) kimértem (ESR-re is), diódákat mértem, hibát nem találtam. Külföldi fórumokon találtam hasonló hibát, csak megoldás nem volt rá... Valakinek valami ötlete?
Előre is köszönöm.
Üdv:Roberto